Preparation For Use - DeWalt DW650LAG Instruction Manual

2. Add fresh, clean, regular unleaded gasoline
with a minimum of 86 octane to the fuel tank
(B). Do not fill above the shoulders on the
debris screen (P) as shown. notE: The
debris screen protects the engine from dirt
and debris, only remove screen when
cleaning. See Cleaning debris Screen under Maintenance for
instructions.
notE: Do not mix oil with gasoline.
3. Replace the fuel cap on the tank. Turn the cap clockwise until it
stops.
oxyGEnAtED FuELs
Some conventional gasolines are blended with alcohol or an ether
compound. These gasolines are collectively referred to as oxygen-
ated fuels.
If you use an oxygenated fuel, be sure it is unleaded and meets the
86 minimum octane rating requirements. Before using an oxygen-
ated fuel, try to confirm the fuel's contents. Some states/provinces
required this information to be posted on the pump. The following are
the EPA approved percentages of oxygenates:
Ethanol (ethyl or grain alcohol) 10% by volume. You may use
gasoline containing up to 10% ethanol by volume. Gasoline contain-
ing ethanol may be marketed under the name gasohol.
CAUTION: Risk of property damage. DO NOT use E85 fuel.
MTBE (methyl tertiary butyl ether) 15% by volume. You may use
gasoline containing up to 15% MTBE by volume.
Methanol (methyl or wood alcohol) 5% by volume. You may use
gasoline containing up to 5% methanol by volume as long as it also
contains solvents and corrosion inhibitors to protect the fuel system.
Gasoline containing more than 5% methanol by volume may cause
starting and/or performance problems. It may also damage metal,
rubber and plastic parts of the engine or your fuel system.
P
If you notice any undesirable operating symptoms, try another
service station or switch to another brand of gasoline.
notE: Fuel system damage or performance problems result-
ing from the use of an oxygenated fuel containing more than the
percentages of oxygenates mentioned above are not covered under
warranty.
location
DANGER: Risk of breathing. Exhaust from the gasoline engine
contains deadly carbon monoxide, which is odorless and toxic.
Operate engine only outside in clean, dry, well-ventilated areas.
noIsE consIDErAtIons
Consult local officials for information regarding acceptable noise
levels in your area.

Preparation For use

1. Place unit on level surface.
2. Check engine oil. See To Check Oil under Maintenance.
CAUTION: Do not operate engine without oil or with inadequate oil.
D WALT is not responsible for engine failure caused by inadequate
e
oil.
3. Check fuel level.
4. See product manual for specific starting procedures.
notE: If any unusual noise or vibration is noticed, stop the engine
and refer to the troubleshooting section as well as the shop
manual.
8