Magnetic Fader Rail Cleaning - Rane TTM 57SL Operator's Manual

Magnetic
Fader Rail
Cleaning
A. Move the carrier all the way to one
side.
B. Use a soft lint-free cloth to wipe off the
rails.
C. Add a drop of silicone lubricant (or
quick spray from aerosol) to the center
of each rail.
D. Move the carrier back and forth to
distribute lubricant.
E. Do not bend the torsion spring or touch
the sensors.
For more effective cleaning and
lubrication, follow the directions below:
1. Required Tool: #1 Philips screwdriver.
2. Disconnect the power.
3. Remove knobs from controls covered
by the Lexan faceplate.
4. Remove the four, 4-40 screws attaching
the Lexan faceplate.
5. Remove the Lexan faceplate. See the
picture and instructions below. The
rails of the fader are now accessible for
normal cleaning and lubrication.
6. Remove fader from mixer if more
thorough cleaning is required.
7. NOTE: Do not disturb the position of
the small sensors at each end of the
Fader. If you do, make sure the parts are
standing straight before reinstalling.
8. NOTE: In order to achieve the highest
possible accuracy, each magnetic fader
is factory calibrated for the location in
which it was shipped. If you remove the
faders for cleaning, make sure you mark
them. This helps you to put them back
in the correct location.
RANE TTM 57SL MIXER FOR SERATO SCRATCH LIVE • OPERATOR'S MANUAL 2.4.4
9. Remove the fader by removing the two
#4 screws securing it. Then disconnect
the ribbon cable.
10. Sugary liquids spilled into a fader may
be removed by thoroughly rinsing the
part in hot water. Make sure the part
is clean and dry before lubricating or
reinstalling.
Remove
#4 screw
Torsion spring
Mark location before
disconnecting ribbon:
PGM 1
PGM 2
XFADER
11. Removal of grease or other stubborn
debris may require alcohol or contact
cleaner. Make sure the part is clean and
dry before lubricating or reinstalling.
12. To reassemble, reverse the
disassembly procedure.
13. Problems? Contact Rane Corporation
customer service at 425-355-6000 or
email us at info@rane.com.
Sensors
Rails
Sensors
Torsion
Spring
Remove
#4 screw
Remove ribbon
49