Rigol DG1022 User Manual page 73

Press the Utility button, enter the following interface (two pages):
Menu Settings
Sync On On
Sync Off Off
CH1
CH2
Coupling
Count
System
I/O
Test/Cal
PA
Instructions
Sync Switch Setting:
When the amplitude is low relatively, you can reduce the distortion when output
the signal by prohibiting the Sync Signal. And the current storage is in the
Non-Volatile Memory.
© 2008 RIGOL Technologies, Inc.
Figure 2-54
Utility Settings Interface
Table 2-22 Utility System Setting
Enable/disable the Sync Signal of CH1 through the
[Sync Out] connector on the rear panel.
Basic Setting of CH1: Impedance, Normal/Inverse
display
Basic Setting of CH2: Impedance, Normal/Inverse
display
Settings of Channel Coupling and Channel Copy
Frequency Measurement in single channel. Range:
100mHz~200MHz
Go to the next page of menus
Set the System Configuration
View the USB Information
Do self-test and calibration operation or view the
instrument information.
Setup power amplifier
Back to the previous page of menus
Save all the settings and exit
User's Guide for DG1022
Explanation
RIGOL
2-49