Related Manuals for Maktec MT191
Summary of Contents for Maktec MT191
- Page 1 INSTRUCTION MANUAL Power Planer MT191 011863 DOUBLE INSULATION IMPORTANT: Read Before Using.
-
Page 2: Specifications
ENGLISH (Original instructions) SPECIFICATIONS Model MT191 Planing width 82 mm Planing depth 2 mm Shiplapping depth 9 mm No load speed (min 16,000 Overall length 285 mm Net weight 2.7 kg Safety class • Due to our continuing programme of research and development, the specifications herein are subject to change without notice. -
Page 3: Planer Safety Warnings
If operating a power tool in a damp location is accessories, or storing power tools. Such unavoidable, use a residual current device preventive safety measures reduce the risk of (RCD) protected supply. Use of an RCD reduces starting the power tool accidentally. the risk of electric shock. -
Page 4: Functional Description
Be sure the blade installation bolts are FUNCTIONAL DESCRIPTION securely tightened before operation. Hold the tool firmly with both hands. Keep hands away from rotating parts. CAUTION: 10. Before using the tool on an actual workpiece, Always be sure that the tool is switched off and •... - Page 5 1. Bolts CAUTION: 2. Drum Do not pull the switch trigger hard without • 3. Planer blade depressing the lock-off button. This can cause 4. Drum cover switch breakage. 5. Adjusting plate Foot 1. Planer blade 2. Rear base 3. Foot 002555 1.
- Page 6 the blades. 1. Mini planer blade 1. Screws 2. Groove 2. Adjusting plate 3. Set plate 3. Planer blade 4. Bolts locating lugs 5. Drum cover 4. Gauge plate 6. Drum 5. Heel of 7. Adjusting plate adjusting plate 6. Set plate 7.
-
Page 7: Correct Setting
(A) Front base (Movable shoe) (B) Rear base (Stationary shoe) Although this side view cannot Correct setting show it, the edges of the blades run perfectly parallel to the rear base surface. Cause: One or both blades fails to Nicks in surface have edge parallel to rear base line. -
Page 8: Maintenance
Shiplapping (Rabbeting) 010183 You may wish to add to the length of the fence by 002580 attaching an extra piece of wood. Convenient holes are To make a stepped cut as shown in the figure, use the provided in the fence for this purpose, and also for edge fence (guide rule). -
Page 9: Replacing Carbon Brushes
Remove and check the carbon brushes regularly. Sharpening the planer blades Replace when they wear down to the limit mark. Keep For conventional blades only the carbon brushes clean and free to slip in the holders. Both carbon brushes should be replaced at the same 1. - Page 12 Makita Corporation www.makita.com 885032-6...
Need help?
Do you have a question about the MT191 and is the answer not in the manual?
Questions and answers