Table of Contents
Advertisement
PARTS AND DIAGRAM LIST
A
B
C
D
Item No.
Quantity
Part Name
A
1
Adjustable wand
B
1
Spray gun
C
1
High-pressure hose
*
D
1
Water filter
E
1
Handle
F
1
Detergent bottle assembly
G
1
Hose bracket
H
1
Gun holder
I
1
Power cord bracket
J
5
Screws
K
1
Needle (
for nozzle cleaning)
* Water filter come pre-attached on the water inlet, located on the front of the pressure washer.
E
F
G
H
I
J
K
5
ASSEMBLY AND OPERATING INSTRUCTIONS
Tools Required
• Philips Screwdriver
Surface Preparation
Before starting any cleaning task, it is important to inspect the area for objects that could
create a hazard. Remove any objects from the work area that could be tripped over, such as
toys or outdoor furniture. Ensure that all doors and windows are closed tightly.
Water Supply (Cold Water Only)
Only draw water through the unit. For use with cold water supply only. Water hose must be
at least a 1/2" (13 mm) in diameter. Flow rate of water supply must not fall below 2 GPM
(gallons per minute) [9.1 lpm (litres per minute)]. Flow rate can be determined by running
the
water for one minute into an empty 5-gallon (19 L) container The water supply
temperature must not exceed 104°F (40°C).
CAUTION
• Never use the pressure washer to draw in water contaminated with solvents (e.g.
paint thinners, gasoline, oil, etc.).
• Dirt in the water inlet will damage the unit.To avoid this risk, we recommend checking
the water
(located inside the water inlet.To clean it out see Maintenance section).
• Always prevent debris from being drawn into the unit by using a clean water source
and an additional accessory water
•To prolong the life of the unit, rest the unit for 5 minutes after every 30 minutes of use.
1
Assemble handle onto pressure washer
and attach hose bracket to handle. Tighten
all the screws.
.
if required.
2
Connect detergent suction tube to the
bottle and attach to the handle.
6
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
Need help?
Do you have a question about the CF1400 and is the answer not in the manual?
Questions and answers
leaking nozzle ...says to call toll-free hotline...i don't have that number :(
To fix a leaking nozzle on a CleanForce CF1400, follow these steps:
1. Make sure the water supply is turned ON.
2. Check for kinks in the garden hose and remove any kinks.
3. Ensure that all hoses and fittings are airtight.
4. Turn off the machine and purge the pump by squeezing the trigger gun.
5. Check the water filter and rinse it in warm water if clogged.
6. Make sure all fittings are tight. Loose fittings can cause leaks.
If the problem continues, the nozzle or seals may be damaged and might need replacement.
This answer is automatically generated