E Stick Deadband - Beastx Aircraft Instruction Manual

E Stick deadband

At parameter menu point E you can adjust the stick dead band for elevator, aileron and rudder. The
deadband is the range around the very center of the stick where the MICROBEAST will not react. Unfor-
tunately, some on the market available transmitters have the problem that when the sticks are brought
back, after an input, to the middle position, they aren't exactly at the same center position as before.
This generates a continuous deviation on the corresponding function, although the stick seems to be
in the middle. This deviation is interpreted as a small input by the MICROBEAST, which lead to an un-
wanted rotation on that axis.
• I f the stick deadband is set to low, it is difficult to find a stick position where no input is sent to the
MICROBEAST. A too low setting here can lead to a tipping helicopter at take off, or a difficult to control
helicopter.
• I f the stick deadband is set to high, you will feel in the middle a large zone where you have no control,
which makes it difficult to have precise hovering.
The choice is made by moving the tail stick
into one direction until the Status-LED
lights in the desired color.
The option "user defined" allows you to
define your own setting with the PC soft-
ware.
Push the button to save the configuration and to proceed to parameter menu point F .
70
Status-LeD
purple
red flashing
red
blue flashing
blue
off
Stick deadband
1
2 *
3
4
5
user defined
*
Factory Setting