Scanning Barcodes - Panasonic CF-P1 Supplementary Instructions Manual

Scanning Barcodes

1
Aim the scanner at the barcode.
2
Press one of the trigger buttons on either side of
the computer.
If the barcode scan application software has been set for use
with F1, F2, F3, or F4 buttons (using
tem] tab - [Barcode Scanner] - [Buttons]), press the button
assigned for this function (
Handheld Computer Operating Instructions).
The red scan beam for reading is emitted from the scanning window. Make sure the red scan
beam covers the entire barcode.
NOTE
It is impossible to scan a barcode for 5 or 6 seconds after turning on the computer
because the barcode scanner is being initialized.
To Correctly Read a Barcode with This Computer, Observe the Following.
The scanning angle is a very important factor. The scanner may be unable to correctly read
a barcode if it is directly perpendicular to the barcode and the red scan beam is reflected
back into the scanner. Perform reading at the angle indicated in the figure. Set at a 15°
angle from the perpendicular position.
Right
Perform scanning so that the red scan beam for reading intersects the barcode itself (in-
cluding at least 12.7 mm {1/2"} beyond each edge of the barcode).
Right
Hold the scanner farther away when reading a larger barcode, and closer in when reading
a smaller barcode or a thinner barcode.
- [Settings] - [Sys-
"Program Buttons" in the
Wrong
Press trigger button.
Wrong
3