Page 1
First-time Operation ® Handheld Computer Supplementary Instructions CF-P1 with Barcode Scanner This Supplementary Instructions explains how to get started with a barcode scanner and point out cases where the operation of the computer will differ from that in the Operating Instruc- tions.
(GSM/GPRS model only). NOTE Close the [Barcode Scanner] settings screen when scanning a barcode. When performing a full reset, CF-P1 restarts automatically to enable the driver for the Barcode Scanner after completing the setup procedure ( “First-time Operation” in...
Scanning Barcodes Aim the scanner at the barcode. Press one of the trigger buttons on either side of the computer. If the barcode scan application software has been set for use with F1, F2, F3, or F4 buttons (using - [Settings] - [Sys- tem] tab - [Barcode Scanner] - [Buttons]), press the button Press trigger button.
Supplementary Instructions Troubleshooting Scanning is not possible. Confirm that the barcode is readable (without damage, etc.) Confirm the range for scanning Be sure the scanner is programmed to read the type of barcode you are scanning. The distance from the scanner to the barcode is impor- tant.
Cleaning the Scanning Window If the scanning window is dirty, gently wipe the scanning window with a cloth or a cotton swab moistened with water. Do not allow materials that can easily scratch the scanning window to touch the window, such as sandpaper or metal object.
Page 6
Supplementary Instructions Symbols Try scanning the following barcodes to check your scanner is working properly.
Specifications Scan Pattern Single Line Scanning Light Source 650 nm Visible light semiconductor laser Decode Capabilities This computer can be programmed to decode the fol- lowing code types : (The readable code depends on the setting.) 1D: UPC/EAN/JAN, UCC/EAN-128, Code39, Code39 Full ASCII, Code93, Code128, I2 of 5, D2 of 5, NW-7 Scan Rate (X direction)