Blomberg DW 14110 NBL00 Use And Care Manual page 14

1 Program lights
2 Rinse aid level indicator light
3 Salt level indicator light
1. Open the door by pulling the door handle. 7
2. Load the dishwasher.
3. Check that both upper and lower spray arms
move freely.
4. Fill enough detergent into the detergent
dispenser and close the lid.
5. Use the On/Off button 8 to turn the dishwasher
on.
6. Check the rinse aid level indicator light. 2
If necessary, refill rinse aid.
(depending on model)
7. Check the salt level indicator light 3 If
necessary, refill salt. (depending on model)
8. Use the Cycle Select button 5 to choose your
washing program.
9. Start the program with the Start/Pause button.
6
10. When the progress indicator light “End” 4
lights up , the wash cycle is completed. Use
the On/Off button 8 to turn the dishwasher
off.
11. Allow your dishes to cool for 20 minutes, with
the door open.
12. Unload the dishes. Begin with the lower rack.
CAUTION
Downloaded from www.Manualslib.com
1 2 3 4
5 6
4 Program follow up lights
5 Cycle Select button
6 Start/Pause button
manuals search engine
7
7 Door handle
8 On/Off button
On / Off
Turn your dishwasher on with the On/Off
button. When turning on, the icon on the
display module of the last used program
will light up.
Start /
Use this button to start the selected
Pause
program; the light on the button lights up.
Stop the program with the Start/Pause
button if you would like to open the door
once the dishwasher’s washing program
is running.
Cycle
Use the Cycle Select button to select the
Select
desired program. The diode of the
corresponding program will light up.
To cancel a program while the
dishwasher is running:
1. Press Start/Pause button for 5
seconds. The indicator light will start
flashing.
2. The dishwasher will drain the water
inside the machine for 45 seconds.
3. The program is cancelled when
indicator light goes off.
4. Then, you can choose and start a
new program.
WARNING
11
8