Installation Tips; Canvas Care And Maintenance; Electric Windshield Vent; Horn - Sea Ray 340 Sundancer Owner's Manual

Hide thumbs Also See for 340 Sundancer:
Table of Contents

Advertisement

S
ECTION
For safety and ease of installation and removal of
canvas, use at least two people. Know which canvas
piece(s) that you are to install or remove.
The standard canvas set consists of the following
pieces:
Sunbrella
®
Bimini Top and Boot
Front Curtains
Aft Sunshade
Canvas Storage Bag
The following canvas options are available:
Cockpit Cover
!
In rainy weather and/or cold weather, fresh air must
circulate through boat to avoid carbon monoxide
poisoning.
See Section 1.4, Carbon Monoxide, for more details.
C
ANVAS
(F
.7.18.1)
IG
FRONT
CURTAINS
A. I
T
NSTALLATION
IPS
Zippers: Zippers are located on each canvas
piece. Make sure canvas is centered over the
metal canvas support rods (bows). When
attaching any canvas piece, zip the zippers only
partially. This helps to hold the piece in place
7.18
7 • O
PTIONS
Side Curtains
Aft Curtain
DANGER
®
SUNBRELLA
BIMINI TOP
AFT SUNSHADE
AFT
CURTAIN
SIDE
CURTAINS
& A
CCESSORIES
and relieves tension, helping the other sides zip
or snap easier. After all the sides of the piece
are snapped in place, finish zipping all the
zippers. This will ensure a tight fit.
Adjustable Support Rods: Adjustable support
rods are located on the Convertible and Bimini
Top. There is an outside tube and an inside
tube. Push in the button to adjust for longer or
shorter rod lengths.
B. C
C
ANVAS
ARE AND
See Section 9, for instructions on the care and
maintenance of your canvas.
16. E
W
LECTRIC
To operate the vent, turn on the battery switch.
To open or close vent, push VENT OPEN or
VENT CLOSE switch on the control station
switch panel.
17. H
ORN
E
H
LECTRIC
ORN
The horn is operated by a momentary switch on
the dash and has a breaker under the dash on the
control station DC breaker panel.
REFER TO OWNER'S MANUAL PACKET FOR
INSTRUCTIONS AND WARRANTY INFORMATION.
340 Sundancer
M
AINTENANCE
V
INDSHIELD
ENT
®
(375 Sundancer
®
)

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 340 Sundancer and is the answer not in the manual?

Questions and answers

David Melton
April 1, 2025

What is the easiest way to pull the shaft

1 comments:
Mr. Anderson
April 1, 2025

To easily pull the shaft on a Sea Ray 340 Sundancer, you can use a custom removal tool made from a 16-inch long 1/2"-20 threaded rod. Attach thick bearing washers on one end and a custom machined puller tool on the other. Use a heavy-wall stainless 2 1/2" tube as a sleeve. After loosening the set screws in the strut, mount the tool, lubricate the nut, washers, and rod with assembly lube, and crank the nut to pull the bearing and shaft out. Repeat the process for the other shaft.

This answer is automatically generated

Table of Contents

Save PDF