Maxi Dot (Information Display) - Skoda Rapid Owner's Manual

Simply clever
Hide thumbs Also See for Rapid:
Table of Contents

Advertisement

Current speed
The current speed which is identical to the display of the speedometer
on page 8 is indicated on the display.
Oil temperature
If the oil temperature is lower than 50 °C or if a fault in the system for checking
the oil temperature is present, only – -.- is displayed instead of the oil tempera-
ture.
Warning against excessive speeds
ä
First read and observe the introductory information and safety warn-
ings
on page 11.
Adjust the speed limit while the vehicle is stationary
With button
» Fig. 5
on page 12, choose the menu point Warning against ex-
A
cessive speeds.
Press the button
to activate the ability to set the speed limit.
B
Use the button
to set the required speed limit, e.g. 50 km/h.
A
Confirm the speed limit by pressing button
settings are saved automatically.
This allows you to set the speed in 5 km/h intervals.
Adjusting the speed limit while the vehicle is moving
With button
» Fig. 5
on page 12, choose the menu point Warning against ex-
A
cessive speeds.
Drive at the desired speed, e.g. 50 km/h.
Press button
to accept the current speed as the speed limit.
B
If you wish to change the set speed limit, it is changed in 5 km/h intervals (e.g. the
accepted speed of 47 km/h increases to 50 km/h or decreases to 45 km/h).
Confirm the speed limit by pressing button
Your settings are saved automatically.
Change or delete speed limit
With button
» Fig. 5
on page 12, choose the menu point Warning against ex-
A
cessive speeds.
Pressing the button
deletes the speed limit.
B
Pressing the button
activates the ability to change the speed limit.
B
If the set speed limit is exceeded, an audible signal will sound as a warning. At
the same time the message Warning against excessive speeds appears on the
display with the set limit value.
14
Using the system
» Fig. 2
3
, or wait several seconds. Your
B
again, or wait several seconds.
B
The set speed limit value remains stored even after switching off the ignition.

MAXI DOT (information display)

ä
Introduction
Ð
This chapter contains information on the following subjects:
Main menu
Settings
Door, boot lid and bonnet warning
Auto Check Control
The information display provides you with information on the current operating
state of your vehicle. The information system also provides you with data relating
to the radio, mobile phone, multifunction display, navigation system, the unit con-
nected to the MDI port and the automatic gearbox
WARNING
Concentrate fully at all times on your driving! As the driver you are fully re-
sponsible for the operation of your vehicle.
Main menu
ä
First read and observe the introductory information and safety warn-
ings
on page 14.
Activate the Main menu by pressing the rocker switch
14
15
15
16
» page
79.
Fig. 6
Windshield wiper lever: Controls
for the information display
» Fig. 6
for longer.
A
Ð
Ð
£

Hide quick links:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Rapid and is the answer not in the manual?

Questions and answers

Table of Contents

Save PDF