Power-On Sequence - Epson ES-800C User Manual

Note:
The SCSI port
diamond shaped icon over it.
If you are connecting the scanner to a SCSI device other than the
computer, use a cable with 50-pin connectors on both ends.
4. The connection is now complete. Connect the power cables.
5. Always turn on the scanner first; then start the computer.

Power-on sequence

You must turn on SCSI devices with terminators (the first and
last devices in the daisy chain) before you turn the computer on
so that information can pass through the SCSI port. If you do
not turn on these devices first, the computer may not start up.
If you have an internal hard disk, turn on the scanner and any
other SCSI devices you plan to use. Wait a few seconds; then
turn on the computer.
If you have an external hard disk, turn on the scanner, external
hard disk (first on the daisy chain), and any other SCSI devices
you plan to use. Wait a few seconds; then turn on the computer.
SCSI devices in the middle of the daisy chain may be left off if
you don't plan to use them.
Now that you have connected the scanner to your computer,
the next thing to do is install the software included in your
Epson interface kit. Follow the directions in the interface kit
and in the software manuals. Then read Chapter 3, "Scanner
Basics," before your first scan.
2-8 Connecting the Scanner to the Computer
the Macintosh is the larger port with the
of