Cub Cadet GTX2154LE Operator's Manual page 22

Lubrication
WARNING!
inspecting, always disengage PTO, set parking
brake, stop engine and remove key to prevent
unintended starting.
Front Wheel Axles
Each of the front wheel axles and rims is equipped with a
grease fitting. See Fig. 6-6. Lubricated after every 10 hour of
operation with Cub Cadet 251H EP grease, or an equivalent No. 2
multipurpose lithium grease.
Steering Housing
The steering housing should be lubricated after every 25 hour of
operation. To access its lube fitting, proceed as follows:
1. Raise the tractor's hood.
2. Locate the grease fitting for the steering housing under the
battery. See Fig 6-7.
22 s 6 — M
ectiOn aintenance
Before lubricating, repairing, or
Grease Fitting
Figure 6-6
Grease Fitting
Figure 6-7
& a
djustMents
3. Using a pressure lubricating gun, apply 251H EP grease, or
an equivalent No. 2 multipurpose lithium grease, through
the grease fitting.
4. Close the tractor hood
Steering Shaft
The steering shaft should be lubricated after every 25 hour of
operation. To access its lube fitting, proceed as follows:
1. Working beneath the left side of the tractor frame, locate
the lube fitting near the rear of the steering housing. See
Fig 6-8.
Figure 6-8
2. Using a pressure lubricating gun, apply 251H EP grease, or
an equivalent No. 2 multipurpose lithium grease through
the steering shaft lube fitting.
Deck Wheels
Each of the tractor deck's gauge wheels is equipped with a
grease fitting. Lubricate with a No. 2 multi-purpose grease
applied with a grease gun after every 25 hours of tractor
operation.
Pivot Points & Linkage
Lubricate all the pivot points on the drive system, parking brake
and lift linkage at least once a season with light oil.
Grease Fitting