Cub Cadet GTX2154LE Operator's Manual page 13

Electric Lift Switch
The electric lift switch located in the right fender and is used to
raise and lower the deck. To lower the deck press down on the
front of the switch and to raise the deck push down on the rear of
the switch.
Cutting Height Lever
LO 1 2
The cutting height lever is used to set the distance the deck can
be lowered. The cutting height lever can be set to six different
positions by moving the lever up or down to the desired setting.
Ignition Switch Module
WARNING!
Never
leave a running
machine unattended.
Always disengage
PTO, set parking brake, stop
engine and remove key to prevent
unintended starting.
To start the engine, insert the
key into the ignition switch and
turn clockwise to the START
position. Release the key into the
NORMAL MOWING MODE
fired.
To stop the engine, turn the ignition key counterclockwise to the
STOP position.
CAUTION:
Prior to operating the tractor, refer to
both Safety Interlock Switches and Starting The
Engine in the Operation section of this manual for
detailed instructions regarding the Ignition Switch
Module and operating the tractor in REVERSE
CAUTION MODE
Forward Drive Pedal
The forward drive pedal is located on the right side
of the tractor, along the running board. Press the
drive pedal forward to cause the tractor to travel
forward. Ground speed is also controlled with
the drive pedal. The further forward the pedal is
pivoted, the faster the tractor will travel. The pedal
will return to its original position when it's not
pressed.
3 4 5 HI
position once the engine has
.
Reverse Pedal
The reverse drive pedal is located on the right side of
the tractor along the running board. Ground speed
is also controlled with the reverse pedal. The further
downward the pedal is pivoted, the faster the tractor
will travel. The pedal will return to its original position
when it's not pressed.
PTO/Blade Engage Lever
Activating the PTO engages power to the cutting
deck or other (separately available) attachments.
Lift up on the PTO/Blade Engage lever to activate
it. Push down on the PTO/ Blade Engage lever to
disengage the power to the cutting deck or other
(separately available) attachments.
NOTE: The PTO/Blade Engage lever must be in
the disengaged (OFF) position when starting the
engine.
Parking Brake/Cruise Control Lever
The parking brake/cruise control lever is located
on the left of the tractor's dash panel. It is used
to engage the parking brake when the tractor is
at rest. Engaging the lever while the tractor is in
motion allows the tractor to remain at a constant
ground speed without applying pressure to the
forward drive pedal. Refer to the Operation section
of this manual for detailed instructions regarding
the parking brake as well as the cruise control
feature.
NOTE: Cruise control can NOT be engaged at the
tractor's fastest ground speed. If the operator should attempt
to do so, the tractor will automatically decelerate to the fastest
optimal mowing ground speed
NOTE: The parking brake must be set if the operator leaves the
seat with the engine running or the engine will automatically
shut off.
WARNING!
Never leave a running machine
unattended. Always disengage PTO, set parking
brake, stop engine and remove key to prevent
unintended starting.
Low Gas Window
The low gas window is located at the rear of
the tractor. If the gas level is visible in this
window, the tank should be re-filled.
s
ectiOn
FILL TANK IF GAS
LEVEL IS SHOWN
IN WINDOW
4 — c & f
OntrOls eatures
13