Troubleshooting - NordicTrack COMMERCIAL 1500 User Manual

Ntl09707.8
Hide thumbs Also See for COMMERCIAL 1500:
Table of Contents

Advertisement

TROUBLESHOOTING

Most treadmill problems can be solved by following the steps below. Find the symptom that applies, and
follow the steps listed. If further assistance is needed, please see the front cover of this manual.
PROBLEM: The power does not turn on
SOLUTION: a. Make sure that the power cord is plugged into a surge suppressor, and that the surge suppressor
is plugged into a properly grounded outlet (see page 11). Use only a single-outlet surge suppres-
sor that meets all of the specifications described on page 11. IMPORTANT: The treadmill is not
compatible with GFCI-equipped outlets.
b. After the power cord has been plugged in, make sure that the key is inserted into the console.
c. Check the reset/off circuit breaker located on the
treadmill frame near the power cord. If the switch pro-
trudes as shown, the circuit breaker has tripped. To
reset the circuit breaker, wait for five minutes and
then press the switch to the reset position.
PROBLEM: The power turns off during use
SOLUTION: a. Check the reset/off circuit breaker (see the drawing above). If the circuit breaker has tripped, wait
for five minutes and then press the switch to the reset position.
b. Make sure that the power cord is plugged in. If the power cord is plugged in, unplug it, wait for five
minutes, and then plug it back in.
c. Remove the key from the console. Reinsert the key into the console.
d. If the treadmill still will not run, please see the front cover of this manual.
PROBLEM: The console displays remain lit when you remove the key from the console
SOLUTION: a. The console features a display demo mode, designed to be used if the treadmill is displayed in a
store. If the displays remain lit when you remove the key, the demo mode is turned on. To turn off
the demo mode, hold down the Stop button for a few seconds. If the displays are still lit, see
HOW TO PERSONALIZE CONSOLE SETTINGS on page 13 to turn off the demo mode.
PROBLEM: The displays of the console do not function properly
SOLUTION: a. Remove the key from the console and UNPLUG THE
POWER CORD. Place the treadmill in the storage po-
sition (see HOW TO FOLD THE TREADMILL FOR
STORAGE on page 22).
Next, remove the two #8 x 3/4" Screws (4).
c
Tripped
Position
a
4
24
Reset
Position
4

Hide quick links:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the COMMERCIAL 1500 and is the answer not in the manual?

Questions and answers

Deborah Ann Jones
January 28, 2025

Trying to unfold treadmill. The knob on bar underneath treadmill is on right side, not the left. The knob doesn't pull out it unscrew off.

User image 679831526358f
1 comments:
Mr. Anderson
February 10, 2025

To unfold the NordicTrack Commercial 1500 treadmill, follow these steps:

1. Hold the upper end of the treadmill with your right hand.
2. Use your left thumb to press the storage latch to the left.
3. Pivot the treadmill until the frame and foot rails move past the storage latch.
4. Hold the treadmill firmly with both hands and lower it to the floor.
5. To reduce the risk of injury, bend your legs and keep your back straight while lowering.

If the knob on the bar does not pull out, ensure that you are applying enough pressure to the storage latch while maintaining a firm grip on the treadmill. If it still does not release, check for any obstructions or misalignment in the latch mechanism.

This answer is automatically generated

This manual is also suitable for:

Ntl09707.8

Table of Contents

Save PDF