Timer Operation - Toshiba TCB-AX21UL Owner's Manual

Wireless remote controller kit
4

TIMER OPERATION

• After the timer has been set, put the
remote controller at a position where
signals of the remote controller can reach
the signal receiving unit on the indoor unit.
The timer operation signal is transmitted
from the remote controller.
• Set the timer while an operation mode is
displayed as follows:
Use the timer in the following
cases
To stop the air
conditioner when the
preset time has
passed
To stop the air
conditioner each time
when the preset time
has passed
To operate the air
conditioner when the
preset time has
passed
Timer period
• The setup time increases by 0.5 hours (30
minutes) each time you push
The maximum setup time is 72.0 hours.
• The setup time decreases by 0.5 hours
(30 minutes) each time you push
The minimum setup time is 0.5 hours.
Timer display
Each time you push Timer
display changes as follows:
ADR
No display
Mode
displayed
OFF timer
Repeat
OFF timer
ON timer
.
.
, the timer
<Use Examples>
▼ Setting OFF timer
(Example) To stop operation in 30
minutes
1
Push Timer
and the time flash on the display.
2
Set the time to 0.5 with TIME
.
3
Push and
▼ Setting repeat timer
(Example) To stop operation in every 2.5
hours
1
Push Timer
and the time flash on the display.
2
Set the time to 2.5 with TIME
.
3
Push and
The OFF timer is activated and the operation
stops in 2.5 hours. When you push
to restart the operation, it stops in 2.5 hours.
▼ Setting ON timer
(Example) To start operation in 8 hours
1
Push Timer
and the time flash on the display.
2
Set the time to 8.0 with TIME
.
3
Push .
The operation mode disappears, and
and the time stop flashing.
▼ Canceling timer operation
Push . The timer display disappears.
– 10 –
Owner's Manual
.
or
go on timer.
twice.
or
go on timer.
again
three times.
or
EN
10-EN