Gdf 570-650 series; gdt 655-695 series; ddt 595 series; pdf 820 series; pdt 825-855 series; cdt 835-865 series; includes ge; ge profile; series and ge café series products (78 pages)
GEAppliances.ca Safety Instructions ...3 Owner’s Manual Operating Instructions Portable Stainless Connecting and disconnecting your Steel Tub Dishwasher dishwasher ....4 Control Panel and Settings.
On dishwashers with electronic controls, if you choose to turn the wall switch off between wash cycles, allow 5–10 seconds after turning the switch on before touching ON/OFF to allow the control to reboot.
READ ALL INSTRUCTIONS BEFORE USING — SAVE THESE INSTRUCTIONS WARNING! RISK OF CHILD ENTRAPMENT PROPER DISPOSAL OF THE DISHWASHER Junked or abandoned dishwashers are Hold nut at top of dishwasher dangerous… even if they will sit for “just a while removing screw few days.”...
Connecting and disconnecting your dishwasher CONNECT THE UNICOUPLE TO THE FAUCET Collar Run garbage disposer, if you have one, Turn on the hot water faucet and check to clean out the disposer and thus allow for leaks. If a unicouple leak was observed, water to drain from the sink through the take whatever actions are necessary to disposer and down the drain.
About the dishwasher control panel Control Settings Power Press the POWER button to turn on the unit to be operated. The LED will be displayed when the dishwasher is on. Programs When the dishwasher is turned on, you can press the PROGRAMS button to select the wash cycle. A light on the display will indicate which cycle has been selected.
GEAppliances.ca Options When the wash cycle has been selected, you can choose the option by pressing the “Options” button. There are three options for “Normal” cycle and “Pots & Pans” cycle. Press the OPTIONS button, “Heated Dry” will be selected; Press the OPTIONS button twice, the “Heated Dry”...
Using the dishwasher. Check the Water Temperature The entering water should be at least 49°C (120°F) thermometer. Turn on the hot water faucet nearest and not more than 65°F (150°F) for effective the dishwasher, place the thermometer in a glass cleaning and to prevent dish damage.
NOTE: Using a detergent that is not specifically and close the cover. designed for dishwashers will cause the dishwasher to fill with suds. During operation, these suds will spill out of the dishwasher vents, covering the kitchen Number floor and making the floor wet.
Loading the Dishwasher Racks. For best performance of the dishwasher,follow these loading guidelines.Features and appearance of racks and silverware baskets may vary from your model. How to use the Upper Rack The upper rack is designed to hold more delicate and lighter dishware such as glasses, coffee and tea cup and saucers, as well as plates, small bowls and shallow pans(as long as they are not too dirty).
GE Cleaning the Spray Arms and the Filters The dishwasher will flush away all normal food soils. However, objects (fruit pits, bones, etc.) may collect in openings and should be removed occasionally to avoid clogging the drain system.
Page 11
Caring for the dishwasher. Cleaning the Spray Arms and the Filters (Continued) Cleaning the Filters main filter and cup under running water. To remove the filter assembly, follow the 3 steps shown below. To clean the main For best performance and results, the filter assembly must filter and fine filter, use a cleaning brush.
Cascade Dishwashing Detergent has been ® approved for use in all GE dishwashers. • To remove suds from the tub, open the dishwasher and let suds evaporate. Add 3.8 liters of cold water to the tub. Close and latch the dishwasher. Repeat if necessary.
Before you call for service… Problem Possible Causes What To Do Dishes and flatware Low inlet water temperature • Make sure inlet water temperature is correct (see page 6). not clean Water pressure is temporarily low • Turn on a faucet. Is water coming out more slowly than usual? If so, wait until pressure is normal before using your dishwasher.
Any part of the dishwasher which fails due to a defect in materials or workmanship. During this From the date of the limited one-year warranty, GE will also provide, free of charge, all labor and in-home service to original purchase replace the defective part.
Contact Us GEAppliances.ca If you are not satisfied with the service you receive from GE, contact us on our Website with all the details including your phone number, or write to: Director, Consumer Relations, MC Commercial Suite 310, 1 Factory Lane Moncton, N.B.