Advertisement
Helpful Information
About Your AM/FM Pi
Remember that no antenna can receive a radio signal that
isn't there. When a usable radio signal is present, your
AM/FM Pi will improve AM and FM reception.
Note: Generally, a practical limit to radio reception is 40-
50 miles from the broadcast transmitter depending on
the terrain.
Gain Control Knob:
Located on the back of the AM/FM Pi is the gain control
knob. The gain control is the mechanism that either
increases or decreases the antenna's amplifier intensity.
The further away you are from the radio signal, the more
you increase the gain. If you are very close to the radio
signal, lowering the gain may have a greater effect.
See Fig. 5.
4
Fig. 4
Fig. 5
Advertisement
Table of Contents
Related Manuals for TERK Technologies PI-B
Summary of Contents for TERK Technologies PI-B
- Page 1 Helpful Information About Your AM/FM Pi Remember that no antenna can receive a radio signal that isn’t there. When a usable radio signal is present, your AM/FM Pi will improve AM and FM reception. Note: Generally, a practical limit to radio reception is 40- 50 miles from the broadcast transmitter depending on the terrain.
-
Page 2: Limited Warranty
This warranty is only valid in the USA. Replacement as provided under this warranty is the exclusive remedy of the consumer. Audiovox shall not be liable for any incidental or consequential damages for breach of any express or implied warranty on this product, except to the extent that limitations of this sort are prohibited by applicable law. - Page 3 PI-B OWNER’S MANUAL AM/FM Pi Powered Indoor Antenna...
-
Page 4: Making Connections
Making Connections With Your New AM/FM Pi Radio tuners and receivers can have different connections for your new Pi antenna. Please find the connection that best matches your tuner or receiver and follow the listed instructions. FM Connections: 75 Ohm Coaxial: Your TERK antenna has a slip-on coaxial connector on the FM lead. - Page 5 AM Connections: AM Push-Button Connection: Your TERK antenna uses a Twin Lead Bare Wire for AM connections. If your radio tuner or receiver has a Push-Button connection, simply slip the bare wires into the push button connections. For a Screw Terminal connection, for wrap the bare wires around the screw terminals and tighten.
- Page 6 Locating Your AM/FM Pi For Best Results 1. All antennas are affected by electromagnetic fields. To maximize performance, position your AM/FM Pi antenna away from direct contact with receivers, tuners, CD players, TVs and computers. Note: Antennas work best when CD players, VCRs and computers are turned off.
Need help?
Do you have a question about the PI-B and is the answer not in the manual?
Questions and answers