Dot1X Critical Recovery Delay - Cisco Catalyst 4500 Series Command Reference Manual

Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches

dot1x critical recovery delay

To set the time interval between port reinitializations, use the dot1x critical recovery delay command.
To return to the default setting, use the no form of this command.
Syntax Description
delay-time
Defaults
Delay time is set to 100 milliseconds.
Command Modes Global configuration mode
Command History Release
12.2(31)SG
Examples This example shows how to set the 802.1x critical recovery delay time to 500:
Switch(config-if)# dot1x critical recovery delay 500
Switch(config-if)#
Related Commands Command
dot1x critical
dot1x critical eapol
dot1x critical vlan
show dot1x
OL-25342 -01
dot1x critical recovery delay delay-time
no dot1x critical recovery delay
Specifies the interval between port reinitializations when AAA transistion
occurs; valid values are from 1 to 10,000 milliseconds.
Modification
Support for this command was introduced on the Catalyst 4500 series switch.
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.3.0SG and IOS 15.1(1)SG)
Description
Enables the 802.1X critical authentication on a port.
Enables sending EAPOL success packets when a port is
critically authorized partway through an EAP exchange.
Assigns a critically authenticated port to a specific VLAN.
Displays dot1x information.
dot1x critical recovery delay
2-203