Scotsman CU50 Installation And User Manual

Scotsman CU50 Installation And User Manual

Cube ice machine
Hide thumbs Also See for CU50:

Advertisement

Installation and
User's Manual for
Cube Ice Machine
Model CU50

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the CU50 and is the answer not in the manual?

Questions and answers

Summary of Contents for Scotsman CU50

  • Page 1 Installation and User's Manual for Cube Ice Machine Model CU50...
  • Page 2: Table Of Contents

    CU50 Installation and User's Manual Introduction: This ice machine is the result of Scotsman’s This manual includes the information needed to decades of experience as an industry leader in the install, start up and maintain the ice machine. Note design and manufacture of both commercial and any Caution or Warning indicators, as they provide residential ice machines.
  • Page 3: Specifications

    CU50 Installation and User's Manual Specifications This ice machine is designed to be used indoors, in Electrical voltage limits: a controlled environment, and under limited • conditions (see page 1), outdoors. It can be used in Minimum - 104 volts •...
  • Page 4: Cabinet Layout

    CU50 Installation and User's Manual Cabinet Layout 98.55 FLOOR DRAIN ACCESS HOLE 3.88 443.23 17.45 606.68 23.89 566.17 22.29 40.51 377.95 1.60 14.88 753.24 29.66 873.25 DRAIN 34.38 FLEXIBLE TUBING 3/8 I.D. PUMP MODEL (INCLUDED) 5/8 I.D. GRAVITY MODEL (NOT INCLUDED) POTABLE WATER INLET 1/4"...
  • Page 5: Air Flow & Control Panel

    They meet or exceed the the ability of the ice machine to make ice. standards of agencies like U.L. Scotsman assumes no liability or responsibility of any kind for products manufactured by Scotsman that have been altered in any way, including the use of any parts and/or other components not specifically approved by Scotsman.
  • Page 6: Water Quality

    • impurities or minerals will have to be regularly be connected to a drain dissolved by an acid cleaning, using Scotsman Ice • be connected to the proper power supply Machine Scale Remover. Directions for this may be •...
  • Page 7: Door Swing Change

    CU50 Installation and User's Manual Door swing change The door can be attached to open with hinges on 6. Remove original bottom hinge. the left or right. To change: 1. Remove top hinge pin from hinge. 7. Remove two plugs or screws from upper cabinet bracket.
  • Page 8: Notes For The Installer

    Sealing to floor: In some cases the base of the ice machine must be sealed to the floor to meet local code. Food grade silastic sealant such as Scotsman part number 19-0529-01 is recommended. Place the machine in the intended location. Turn the leg levelers in until the bottom of the unit is as close to the floor as possible.
  • Page 9: Installation: Water & Drain

    CU50 Installation and User's Manual Installation: Water & Drain The recommended water supply tubing is ¼ inch Drains OD copper. Install an easily accessible shut-off valve between the supply and the unit. This shut-off There are two types of ice machine models, one valve should not be installed behind the unit.
  • Page 10: Gravity Drain

    CU50 Installation and User's Manual Gravity Drain Caution: Restrictions in the drain system to the outlet of the barbed connector and secure with a machine will cause water to back up into the ice clamp. Leave the other end of the tube lying on the storage bin and melt the ice.
  • Page 11: Electrical

    CU50 Installation and User's Manual Electrical The ice machine is supplied with a power cord. Do not remove the grounding pin from the cord’s plug. Do not use extension cords. Follow all codes. Connect the machine to its own 115 volt, 15 amp circuit.
  • Page 12: Start Up

    CU50 Installation and User's Manual Start Up Check list: After about a half hour, ice will fall into the ice storage bin. The machine makes 24 cubes per 1. Has the unit been connected to the proper batch. It is normal for the first batches of ice to water supply? melt, that continues until the bin has cooled.
  • Page 13: Use

    CU50 Installation and User's Manual No special instructions are needed for use. Just take as much ice as you need, the machine will replace it. A scoop is provided, and it can be stored in the machine using the loop of tubing on the right side as a holder.
  • Page 14: How To Clean The Condenser And Winterize

    CU50 Installation and User's Manual How to clean the condenser and winterize. Condenser cleaning Winterizing The condenser is like the radiator on a car, it has 1. Clean the ice making system. fins and tubes that can become clogged with dirt and lint.
  • Page 15: Remove Scale

    F.) potable water. light will blink on and off. 2. Remove the top panel. 4. Pour 4 ounces of Scotsman Ice Machine Scale Remover (available from a local Scotsman 3. Pour 2 quarts of sanitizer solution onto the top of Distributor or Dealer) into the ice machine the ice making platen.
  • Page 16: What To Do Before Calling For Service

    If outdoors and the air temperature is below 50 degrees F., the machine may not operate. Time to Clean light is on • Clean the ice making system. SCOTSMAN ICE SYSTEMS 775 Corporate Woods Parkway, Vernon Hills, IL 60061 800-533-6006 www.scotsman-ice.com 17-3314-01...

Table of Contents