Sharp PA-VR10E PC Operation Manual page 24

Press the OK button to confirm the displayed hour.
4
The "minutes" setting then starts flashing.
Press the
5
select the minutes.
Press the OK button to confirm the displayed minutes.
6
The "hour" setting for the end time then
starts flashing. Use the same procedure to
select the hour and minute settings for the
end time.
After you have confirmed the "minutes" setting, press the
7
OK button.
This completes the time setting procedure and returns you to
the menu screen.
Tip
Press the 1 cursor button to go to the preceding setting. Press the
0 cursor button to go to the next setting.
• Recording begins slightly before the scheduled recording time.
• Settings such as the recording mode and microphone sensitivity
used for scheduled recording are those that were set before
recording begins.
• If the scheduled time is reached while you are playing a
recording, playback stops and the recorder starts recording.
• If the scheduled time is reached while the digital voice recorder
is connected to a personal computer, a flashing indication
appears on the display and recording does not take place.
To cancel the settings
Display the automatic recording settings screen. (See steps
1
1 and 2 on page E-21.)
Press the ERASE button.
2
"DEL.?" appears on the display.
Press the OK button.
3
"DELETE!" appears and the settings are deleted.
Message alarm function
This function enables the recorder to play a pre-recorded message or
sound an alarm tone at a set time. You can set up to 3 alarms at one
time.
E-22
L M
(+) or (-) cursor button to