Preparing The Remote Control; Speaker Placement - Kenwood VR-506 Instruction Manual

Speaker placement
Frontspeakers: Placetothefront left and right ofthelistening position
Front speakers are required for all surround modes
Center speaker : Place front and center This speaker stabilizes the
sound image and helps recreate sound motion Se sure to connect a
center speaker when using the Dolby 3 Stereo mode
Surround speakers : Place to the direct left and right, or slightly
behind, the listening position at even heights, approximately 1 meter
above the ears of the listeners These speakers recreate sound motion
and atmosphere Required for surround playback
Subwoofer : Reproduces powerful deep bass sounds
l
Although the ideal surround system consists of all the speakers listed
above, if you don't have a center speaker or a subwoofer, you can
divide those signals between the available speakers in the speaker
settings steps to obtain the best possible surround reproduction from
the speakers you have available
-a
hannel space switchins
kcepf for fhe USA, Canada, UK, Europe, and Australia)
te space between radio channels has been set to the one that prevails
the area to which the system is shipped However, if the current
cannel space setting does not match the setting in the area where the
stem is to be used, for instance when you move from area 1 or area
shown in the following table or vice versa, proper reception of AM/FM
oadcasts cannot be expected In this case, change the channel space
:tting in accordance with your area by referring to the following table
ove switch lever to match your area with a small screwdriver or
her pointed tool
Preparing the remote control
1
LOadinQ the batteries
0 Remove the cover
8 Insert the batteries
1 Q Close the cover
l
Insert two AA-size (R6) batteries as indicated by the polarity markings
Operation
When the STANDBY indicator is lit, the power turns ON when you press
the POWER key on the remote control When the power comes ON,
press the key you want to operate
6m
I--
ray system
l
When pressing more than one remote control key successively, press
the keys securely by leaving an interval of 1 second or more between
keys
Notes
1 The supplied batteries may have shorter lives than ordinary batteries due
to use during operation checks
2 When the remote-controllable distance gets shorter than before, replace
both batteries with new ones
'6
3 Placing the remote sensor in direct sunlight, or in direct light from a high
frequency fluorescent lamp may cause a malfunction
In such a case, change the location of the system installation to prevent
malfunction