NAD C 427 Owner's Manual
  1. Manuals
  2. Brands
  3. NAD Manuals
  4. Tuner
  5. C 427
  6. Owner's manual

NAD C 427 Owner's Manual

Am/fm tuner
Hide thumbs Also See for C 427:
Table of Contents

Advertisement

Quick Links

See also: Service Manual
C 427
®
AM/FM Tuner
Owner's Manual

Advertisement

Table of Contents
loading

Related Manuals for NAD C 427

Summary of Contents for NAD C 427

  • Page 1 C 427 ® AM/FM Tuner Owner’s Manual...

  • Page 2: Important Safety Instructions

    IMPORTANT SAFETY INSTRUCTIONS SAVE THESE INSTRUCTIONS FOR LATER USE. NOTE TO CATV SYSTEM INSTALLER FOLLOW ALL WARNINGS AND INSTRUCTIONS MARKED ON THE AUDIO This reminder is provided to call the CATV system installer’ s attention to Section 820-40 of EQUIPMENT. the NEC which provides guidelines for proper grounding and, in particular, specifies that the cable ground shall be connected to the grounding system of the building, as close to Read instructions - All the safety and operating instructions should be read...
  • Page 3 RECORD YOUR MODEL NUMBER (NOW, WHILE YOU CAN SEE IT) The model and serial number of your new C 427 are located on the back of the cabinet. For your future convenience, we suggest that you record these numbers here: THE EQUIPMENT MUST BE CONNECTED TO AN EARTHED MAINS SOCKET-OUTLET.

  • Page 4: Table Of Contents

    GETTING STARTED ..........5 easy to use. We have been careful to ensure that the C 427 is as musically WHAT’S IN THE BOX .

  • Page 5: Introduction

    4 Plug the AC mains plug also of your amplifier to a mains power source. Power up your amplifier and set it to the tuner input where the C 427 is connected. 5 Press the front panel STANDBY button to turn ON the C 427. The Standby LED indicator will turn from amber to blue and the VFD is illuminated.

  • Page 6: Identification Of Controls

    NOTE used in deleting stored presets. Refer also to the item about In order to turn ON the C 427 from standby mode or back to standby DELETE A PRESET at the LISTENING TO AM/FM RADIO section of the mode, the rear panel POWER switch must be in the ON position.

  • Page 7: Rear Panel

    © NAD C 427 ATTENTION! Please make sure that the C 427 is powered off or unplugged before making any connections. It is also advisable to power down or unplug all associated components while making or breaking any signal or AC power connections.

  • Page 8: Tnr 3 Remote Control

    To cancel the sleep mode, continue pressing the TNR 3’s [SLEEP] button until “Sleep Off” is displayed on the VFD. Switching the C 427 to standby mode from either the TNR 3’s [OFF] button or the front panel Standby button will also cancel the sleep mode.

  • Page 9: Operation

    “4”, “5” and “0” or press “1”, “0”, “4” and “5”. STORING PRESETS The C 427 can store a mix of your 40 favorite AM and FM stations for immediate recall. 1 To store a desired AM/FM station to a preset, first tune to the desired frequency, then press the front panel’s [MEMORY] button.

  • Page 10: Reference

    AH Reset… complete For C version units • Press and hold both the front panel [FM] and [BLEND] buttons until the VFD shows C Reset… complete The C 427 is now restored to its factory default settings with all Presets cleared.

  • Page 11: Specifications

    * : 60 dBμ, L=R 75 kHz for 120V version; 40 kHz Dev for 230V version NAD SHALL NOT BE HELD LIABLE FOR ANY TECHNICAL OR USER INTERFACE DISCREPANCIES IN THIS MANUAL. THE C 427 OWNER’S MANUAL MAY BE SUBJECT...
  • Page 12 All rights reserved. NAD and the NAD logo are trademarks of NAD Electronics International, a division of Lenbrook Industries Limited. No part of this publication may be reproduced, stored or transmitted in any form without the written permission of NAD Electronics International.

Table of Contents