Linking The Solar Siren To The Control Panel; Testing The Wireless Solar Siren; Mounting The Solar Siren On To The Wall - Response SL3 Installation And Operating Manual

LINKING THE SOLAR SIREN TO THE
CONTROL PANEL
When you power up the siren it will automatically be
in Service Mode. It cannot be switched out of
Service Mode or respond to the control panel until the
control panels has been linked to it and the panels ID
code learnt into the siren's memory. The siren needs
to be placed into Learn Mode to complete this.
The full learning process including the actions at the
siren is as follows:
1. Ensure that the system is in Test Mode.
,
Press 1
User Access Code
The arm and Part-Arm LEDs will flash.
2. Place the siren into Learn Mode:
To switch the Siren into Learn Mode, press-and-
hold the Learn button inside the sirens battery
compartment for 5s until the siren enters Learn
Mode and produces a single short low volume
beep and both Learn and Indicator-LEDs start
flashing together slowly (once every 2 seconds).
If there is already a Control Panel linked to
the siren then it is not possible to add
another. The siren will produce a single long
beep and exit Learn Mode.
The siren will remain in Learn Mode for 30s.
If a valid signal is not received from a Control
Panel within that period it will automatically exit
Learn Mode. It will remain in Service Mode.
3. Send the ID codes from the panel to the Siren:
7
Press
ENTER
Zone 1 LED will flash for 15s while the codes
are transmitted.
After 2 seconds the "Siren Stop" signal will be
transmitted by the panel to the siren to learn the
panel's code.
The siren will produce a single short beep
and the Indicator/Learn LEDs will start
flashing together rapidly, (once every second).
,
2 3 4
ENTER
After 10s the "Siren Stop" signal will automatically
be retransmitted by the Control Panel for the
siren to confirm the control panels ID code.
The siren will produce single long beep and
the Indicator/Learn LEDs will stop flashing
and remain ON for 3 seconds after which it
will go out to indicate that the Control Panel
is now linked to the Siren and its ID code
recorded in memory.
!
9
4. Press and
Off before attempting to test the Solar Siren.
The siren will produce a single long beep
followed 1 second later by two short beeps.
The Siren LEDs will flash together in conjunction
with the beeps to indicate that it has switched
out of Service Mode.
Now test the Siren as follows:
IMPORTANT: The use of ear defenders at this
stage is advisable

TESTING THE WIRELESS SOLAR SIREN

With the Control Panel in Test Mode, press
to select Siren Test.
The External Siren will be operated for a period of
approximately 5 seconds.Zone LED 2 will be
illuminated during the test. Wait for the test to end.
5. If this is a new installation, mount the Siren onto
the wall as follows:
MOUNTING THE SOLAR SIREN ON
TO THE WALL
6. Hold the clear plastic mounting template supplied
in position and mark the positions of the four
mounting holes. A spirit level placed on the top
edge will help ensure you get the unit level.
7. Undo the fixing screw securing the mounting
plate from the bottom edge of the siren and
remove the plate.
8. Drill four 6mm holes and fit the wall plugs.
9. Fit the two 30mm fixing screws in the top holes
leaving approximately 9mm of the screw protruding.
for entry Service Mode
ENTER
2
ENTER
21