Parking Brake; Seat; Fuelling - Husqvarna Rider Pro 18 Operator's Manual

Parking brake

The parking brake is applied as follows:
1. Push down the brake pedal (1).
2. Fully depress the lock button on the steering
column (2).
3. Release the brake pedal while holding the
button pressed.
The parking brake lock disengages automatically
when the brake pedal is pressed.

Seat

The seat has a jointed attachment on the front edge
and can be tipped forward.
The seat can also be adjusted lengthways.
To adjust move the lever under the front edge of
the seat to the left, so that the seat can be moved
forward or backwards to the required position.
The seat springing can be adjusted by moving the
rubber stops in their mountings on the underside of
the seat. Place both stops in the front, middle or
rear position.

Fuelling

The engine runs on unleaded petrol with a
minimum octane rating of 87 (not mixed with oil).
We recommend the use of biodegradable alkylate
petrol. Refer to the "Technical data" for information
on methanol and ethanol fuels.
Do not fill the tank completely, leave an expansion
area of at least 2.5 cm (1").
WARNING!
Petrol is highly inflammable.
Exercise care and refuel outdoors
(see safety instructions).
Lights and power outlet
The lights are switched on and off using the power
switch (1) on the control panel.
A seat heater or mobile phone charger are
examples of articles that can be connected to the
power socket (2). The power outlet is switched on
and off using power switch (3) on the control panel.
PRESENTATION PRO 18
1
2
3
19
English –