Hitachi Plasma Display Monitor User Manual page 58

Make sure the monitor power is switched off (with the standby/ receive lamp switched off or red)
before you connect or disconnect the speaker cables.
Attach the speaker systems to the monitor.
1
2
3
Be sure to insert the speaker cables securely.
Lock the connection terminal level securely.
Downloaded from www.Manualslib.com
Caution
Attach the speaker brackets to the speaker systems.
Attach the screws in a position that allows you to read the speaker holder orientation markers (R), (L).
In the case of (R)
Speaker holder
screw X 2
R
Speaker
screw X 2 holder
Attach the speaker systems to the monitor.
Remove two screws on each side of the monitor
as shown and keep them for re-install. Loosen
two screws on each side of the monitor as
shown so that the speaker holders can be slide
on to them. Insert the loosened screws into the
engaging holes of the speaker holders that are
attached to the speaker system, and slide the
screws downwards. Next, use the previously-
removed screws to fasten the speaker holders
into the mounting holes in the monitor. Tighten
the four screws to secure.
Attach the connection cables to
the speaker system.
Speaker terminals
Connect the copper-coloured
Treating the wire ends
wire to the
Pull off while twisting
Connect the silver-coloured
wire to the
Please prepare the supplied
speaker cables.
How to connect
Press down Insert the
the speaker
the lever with wire
cables
your finger
(Speaker side)
Caution required
manuals search engine
(R) (L)
Notice
Use of cushions
In some cases, there can
be a gap between the main
unit and the speaker. You
can attach the cushions
provided to the side of the
speaker system, if desired,
to eliminate the gap.
Cushion
Right side
Remove
Loosen
screws
screws
Ω
Monitor rear side
Attach the speaker connection
4
cables to the monitor.
+
side
- side
How to connect
Remove
the speaker
your finger
cables
(Monitor side)
Cushion
Attach the cushions
to the sides of the
speakers facing the
main unit.
Align the cushions
to the front of the
back case and affix
them.
Back case
Speaker holder
shown the other side
Remove
SPEAKER TERMINAL
(8Ω8W) screws
Hook this section
on the loosened
screw
- +
Black Red
Ω
Ω
Connect Connect
the silver- the copper-
colour wire colour wire
Press the Insert the
lever down wire
Ω
Raise the
lever