Husqvarna DT22 Operator's Manual page 42

12. Slide wheel on and apply two (2) retaining
rings. (Some units use a cotter pin instead.)
NOTE: The teeth on the retaining rings should point
away from the wheel.
13. Tighten wheel bearing hardware on both sides.
NOTE: If you have not installed the flail reel shaft,
do so now.
14. Install rubber flaps between flail blades on the
rake shaft. See Figure 3. If this shaft is installed,
you DO NOT have to remove the shaft from
the unit to install the the rubber flaps.
FIGURE 3
15. Remove belt guard. Remove cable by remov-
ing the pulley. See Figure 4. Attach new cable
and replace pulley. Save the old cable for use
when the bagger is not used.
42
BAGGER ASSEMBLY
RUBBER FLAP
PULLEY
FIGURE 4
16. Attach the chute to the mainframe.
FIGURE 5
17. Install two extenders on the outside of the lower
handle assembly. Attach the lanyards with pins
to the extenders as shown in Figure 6.
CABLE
DT11
CHUTE
DT12