Engine Oil - Husqvarna DT22 Operator's Manual

1. Engine oil

The engine should be warm (but not hot) when
changing the oil. Warm oil flows out faster and
leaves a smaller quantity of old oil inside the
engine.
1. Place a suitable vessel underneath the oil
drainage screw. Remove the oil dipstick (1)
and the oil drainage screw (4).
Tip: Make a channel using a piece of cardboard
to lead the oil directly into the vessel and avoid
soiling the machine chassis.
2. Allow the engine oil to drain into the vessel;
then replace the drainage screw. Tighten it
moderately.
IMPORTANT INFORMATION
Used engine oil is a health hazard and
legislation prohibits disposal on the ground
or in nature; it should always be disposed
of at a workshop or appropriate disposal
location. Avoid skin contact; wash with soap
and water in case of spills.
3. Make sure the machine is parked on even
ground. Fill the new oil using the appropriate
viscosity according to the diagram, API
Service SF-SG, to the upper level mark on the
dipstick = threads on the oil dipstick. The
engine takes 0.6 liters/0.63 US qt of oil. When
checking the oil level, the dipstick should not
be screwed in.
4. Check that the rubber gasket is in position and
screw the dipstick back into place. Do not
tighten it askew or too hard or you may
damage the threads.
5. Wipe up any spilled oil.
Checking the engine's oil level.
Make sure that the machine is parked on even
ground with the engine stopped when checking
the oil level.
1. Unscrew the dipstick and wipe it using paper
towel or a lint-free rag.
2. Replace the dipstick without screwing it in.
Remove and check the level on the dipstick.
3. Fill oil as necessary to the lip of the dipstick
hole. Oil type, see above.
LUBRICATION
4. Check that the rubber gasket is in position
and screw the dipstick back into place. Do
not tighten it askew or too hard or you may
damage the threads.
WARNING!
Engine oil can be very hot if it is drained
directly after stopping the machine.
Allow the engine to cool somewhat.
8011-045
8011-046
8011-020
35