Correct Usage; Preparation - Sharp HV-50CXE Operation Manual

CORRECT USAGE

1

Preparation

Place the unit on a level surface within
1
the room and insert the power plug into
the wall outlet.
• Be sure to place the unit on a stable, level sur-
face.
• Place the unit not directly exposed to air from air
conditioners and heat from heaters.
• Read "Correct placement" (Page 5)
Hold the tank handle and remove the
2
tank.
Remove the tank cap and pour water.
3
• Use drinkable tap water.
(Conventional tap water is sterilized with chlo-
rine to suppress propagation of bacteria.)
• Read "Do not use other than top water" (Page 6)
After supplying water, securely tighten
4
the tank cap.
• Check to see that there is no water leak.
• Be sure to wipe off any excess water around the
tank.
5 Set the tank into the unit.
• Hook the groove on the tank to the tab on
the unit.
The unit may not operate if the tank is set
at an angle.
(Align the
mark on the unit.)
CAUTION
• Do not expose the unit to water. Short circuit and/or electrical shock may occur as a result.
• Do not use hot water of 40°C or higher, chemical agents, aromatic substances, dirty water, etc. Deforma-
tion and/or malfunction may occur as a result.
• Do not use mineral water, ionized alkaline water, well water, purified water, etc. Propagation of mold
fungus and bacteria may occur as a result.
• Securely tighten the tank cap. If the tank cap is difficult to tighten, loosen the cap one full turn to properly
set the cap to the tank.
10
mark on the tank and the
Tank handle
Remove the tank
Tank
Tank cap
Pour water
Tank
Tighten tank cap.
Set the tank.
Tank mark
Unit mark
Tab on unit
Tank
cap
Groove on tank