Table of Contents
Advertisement
2
Run a terminal program on the PC connected to the 10101 port. The serial
port settings should be: 9600 baud, 8 data bits, 1 stop bit, no parity, and no
flow control.
3
Turn on the switch.
4
In the terminal program, when the prompt "Hit any key to stop autoboot"
appears, press any key. A menu will be displayed.
5
Enter <1> (Boot Alternate) and press <Enter>. The SCS will
automatically reboot to the previous firmware version.
6
After the SCS reboots, attempt the upgrade.
Property Identity and Location Settings
The switch can report most device properties directly through the switch web
browser. Clicking Identity displays the Unit Identification Properties screen and
provides the Part Number, Serial Number, and status of the Dell Remote Access
Key. The Unit Location Properties screen displays the Site, Department, and
Location.
NOTE: After changing network settings, the switch must be rebooted.
Viewing Version Information
The Version screen displays version information of the Current Application,
Boot, Build, Hardware, UART, and Video ASIC versions. This screen is a read-
only screen.
Network Settings
NOTE: Only SCS administrators can make changes to the Network dialog box settings.
Other users will have view only access.
From the side navigation bar, click Network to display the General, IPv4, and
IPv6 tabs.
xxx
|
68
OBWI Operation
xxx
Advertisement
Table of Contents
