Table of Contents
Advertisement
On a Call
Switching
Between
Handset and
Speakerphone
Microphone
(Mic/Mute)
Button
Hold
Exclusive Hold
Automatic Hold
Consultation Hold
VIPedge UG
12/12
While on a call you can perform the following:
Press Spkr and place the handset on-hook to switch from handset to
speakerphone mode.
Take the handset off-hook to switch from speakerphone to handset mode.
This button toggles between Mic and Mute. When Mic button is lit, handsfree
communication is supported, when Mic is pressed again and light is off, Mute is
enabled and mutes both the microphone and the handset.
To place a call on hold, press Hold. Your LCD shows the line on hold. The held
Line's LED flashes green while appearances of the line at other stations flash red.
To return to the held call, press the flashing held Line button.
•
If you do not return to the held call within a specified time, it rings back to your
•
telephone. The call remains camped-on to your station.
If the held party hangs up, the call is released.
•
See the Call Pickup section to pick up a call on hold from another extension.
•
This feature enables you to place a call on hold so that only you can retrieve it.
While on a call, press Hold twice. That line's LED flashes green while
appearances of the line at other stations are steady red (in use).
This features enables you to move from one Line button to another Line button
without pressing Hold.
Check with your System Administrator to make sure this setting is turned on. If
Automatic Hold is not enabled, calls will drop when moving from one line to
another without pressing Hold.
While on a call, press another extension button to receive/originate a new call.
The accessed line's LED flashes (in-use). The first call is put on hold and your
extension's LED flashes.
1. While on a call, press Cnf/Trn. The call goes on hold.
2. Dial another line.
3. Transfer the call or return to the held call by pressing its Line button.
TOSHIBA
VIPedge
The Basics
21
Advertisement
Table of Contents
