Page 1
Phoenix (8612) Non-Catalytic Wood Stove OWNER'S MANUAL INSTALLATION AND OPERATING INSTRUCTIONS PLEASE READ THIS ENTIRE OWNER’S MANUAL BEFORE YOU INSTALL, AND USE, YOUR NEW PHOENIX WOOD STOVE. To reduce the risk of fire, follow the installation instructions. Failure to follow these instructions may result in property damage, bodily injury, or even death.
Make sure to install your stove: cardboard, coal, garbage, or driftwood. According manufacturer's Especially, do not burn coal in this stove. recommendations Phoenix Model 8612 HearthStone Quality Home Heating Products Inc ®...
• Inspect and, if necessary, clean your Install a good smoke detector, preferably in an area away from your wood stove. chimney. • Thoroughly clean the inside of the stove. Phoenix Model 8612 HearthStone Quality Home Heating Products Inc ®...
ONTO HearthStone’s Thermo-Ceramic Baffle System To enhance the combustion efficiency and reduce the emissions of the fire in your stove HearthStone QHHP, Inc. has developed an advanced THERMO-CERAMIC baffle system. This system uses a lightweight, durable ceramic material above the burner tubes to maintain the high temperatures in the secondary combustion area and maintain the low emission –...
Polished gray soapstone is a natural product and will vary from stone to stone. Various amounts of gray, charcoal, blue and green are usually evident, and vary according to the natural composition of the stone. Phoenix Model 8612 HearthStone Quality Home Heating Products Inc ®...
(stovepipe typically the surfaces per NFPA 211 standards. exiting vertically up from the stove into a close Phoenix Model 8612 HearthStone Quality Home Heating Products Inc ®...
The advantage of providing outside air directly to the stove is that the air used by the stove for Phoenix Model 8612 HearthStone Quality Home Heating Products Inc ®...
B: Back wall to stove: 13” (33 cm) C: Back wall to pipe: 9” (23 cm) Corner Installation: A: Wall to stove corner: 12” (31 cm) B: Wall to pipe: 18” (46 cm) Phoenix Model 8612 HearthStone Quality Home Heating Products Inc ®...
Page 11
Residential and Mobile Home Installations for USA/Canada – Rear Exit Maintain 18” min. clearance between horizontal chimney connector and ceiling. Parallel Installation: A: Side walls to stove: 20” (51 cm) B: Back wall to stove: 25” (64 cm) HearthStone Quality Home Heating Products Inc ® Phoenix Model 8612...
Page 12
C: Back wall to pipe: 5” (13 cm) D: Top of stove to ceiling: 36” (91 cm) The minimum alcove size: Height: 64” (163 cm) Width: 40” (102 cm) Max. Depth: 48” (122 cm) HearthStone Quality Home Heating Products Inc ® Phoenix Model 8612...
NFPA recommended clearances from ceiling. However, other minimum Close clearance recommendations are exceeded when following pipe wall 5” (127 the required clearances for the stove to combustible materials, because our stove Phoenix Model 8612 HearthStone Quality Home Heating Products Inc ®...
Holes pre-drilled in the flue collar accept #10 (1/8”) x ½” (3 mm x 13mm) sheet metal screws. Additional stovepipe accessories such telescoping pipes, draw-bands, slip connectors, HearthStone Quality Home Heating Products Inc ® Phoenix Model 8612...
When purchasing a prefabricated chimney to accumulation. install with your stove, be sure to also purchase from the same manufacturer the wall pass- through (or ceiling support package), "T" HearthStone Quality Home Heating Products Inc ® Phoenix Model 8612...
Page 17
C h im n e y is s u p p o r te d b y T e e S u p p o r t B ra c k e t. C h im n e y is s u p p o r te d b y C e ilin g . Phoenix Model 8612 HearthStone Quality Home Heating Products Inc ®...
Chimney wall construction: of 13 feet (4 m). The maximum allowable chimney height feet (9m). Brick or modular block at least 4" (102 mm) thick. A mortared rubble or stone wall. HearthStone Quality Home Heating Products Inc ® Phoenix Model 8612...
DO NOT INSTALL IN A ROOM USED FOR SLEEPING. ▌ CAUTION: MAINTAIN STRUCTURAL INTEGRITY OF THE MOBILE HOME WALLS, FLOOR, CEILING, AND ROOF WHILE YOUR STOVE IS INSTALLED, AND IN USE. HearthStone Quality Home Heating Products Inc ® Phoenix Model 8612...
ASH PAN: The ash pan, and ash pan access door, is located under the ash lip. The ash pan collects ash from the fire and allows you to conveniently remove the ash from your wood Phoenix Model 8612 HearthStone Quality Home Heating Products Inc ®...
Do not store firewood within the stove's your stove. If any odor persists, contact your specified clearances to combustible materials. dealer or an authorized service technician. Phoenix Model 8612 HearthStone Quality Home Heating Products Inc ®...
3) Light the paper under the kindling. Leave door slightly ajar momentarily until the kindling has started to burn and draft begins to pull. Phoenix Model 8612 HearthStone Quality Home Heating Products Inc ®...
6) Once the fire is burning well, use the primary air control to regulate the desired rate of burn. Push the handle to the left to open the PRIMARY AIR Phoenix Model 8612 HearthStone Quality Home Heating Products Inc ®...
FIRING WILL VOID YOUR WARRANTY!! EMOVAL ISPOSAL SHES Remove ashes only when the stove is cold. Use protective fireplace gloves when the pan is Phoenix Model 8612 HearthStone Quality Home Heating Products Inc ®...
2. After reloading with wood, burn the stove with the primary air control fully open for 20 to 30 minutes. This manner of operation Phoenix Model 8612 HearthStone Quality Home Heating Products Inc ®...
Page 26
To clean off the hinges with the hinge pins heavier deposits, open the door and lift it remaining in the door. straight up and off the stove with the hinge pins Phoenix Model 8612 HearthStone Quality Home Heating Products Inc ®...
Exterior cast iron parts are either painted with Your stove's performance is also dependant on black, high-temperature stove paint its installation. One common cause of poor Phoenix Model 8612 HearthStone Quality Home Heating Products Inc ®...
Page 28
WIND VELOCITY: Generally, the stronger and steadier a wind, the stronger (better) the draft. However, "gusty" wind conditions may cause erratic downdrafts. BAROMETRIC PRESSURE: Chimney drafts are typically sluggish on balmy, wet or Phoenix Model 8612 HearthStone Quality Home Heating Products Inc ®...
Page 29
Do not over-fire the stove. Monitor stove temperatures. Use ENAMEL CASTING seasoned wood only. Excessive Draft Check the DRAFT. A damper may be required. Operate the stove at a LOW BURN range. HearthStone Quality Home Heating Products Inc ® Phoenix Model 8612...
AIR INLET/ASH PAN BOX PRIMARY AIR CONTROL SLIDER 5012-056 PRIMARY AIR CONTROL SLIDER 5012-057 HANDLE 5012-066 PRIMARY SHUTTER BUSHING 5012-304 FRONT BAFFLE SUPPORT 5400-2202A ASH DOOR SHAFT 5400-2205 DOOR LATCH/SHAFT HearthStone Quality Home Heating Products Inc ® Phoenix Model 8612...
“Original Purchaser”) the new woodstove manufactured by HearthStone and purchased by the Original Purchaser (the “Woodstove”) against any of the occurrences listed in this document that result from defects in material or workmanship. All obligations of HearthStone under this document commence on the date the Original Purchaser purchases the Woodstove (the “Purchase Date”).
Page 33
To obtain performance of any obligation under this document, the Original Purchaser must, within the applicable warranty time period, contact HearthStone, at the address listed in the Warranty Registration section below or at (802) 888-5235, or a Dealer for instructions regarding the return of defective parts for repair, the return of the Woodstove for repair, or a Dealer service call.
Page 34
Dealer or allow a Dealer to make a service call at the place where the Woodstove is located. In the event the Original Purchaser refuses to allow a Dealer to make a service call, HearthStone or a Dealer, as the case may be, will request that the Original Owner return the defective part, or the entire Woodstove (if needed), with shipping prepaid, to HearthStone or a Dealer.
Need help?
Do you have a question about the Phoenix 8612 and is the answer not in the manual?
Questions and answers