Oasis Mirage Instruction Manual page 11

Problem
Water dispenser is leaking
Water is not hot or cold enough
Water dispenser is not dispensing
water
When using direct water hookup;
slow or no water into the cooler
Water dispenser is noisy
oasiscoolers.com
Possible Cause
Drain cap and silicone seal are not secure.
All the water in the tank has been used.
The unit is unplugged.
The circuit breaker is tripped or a fuse is blown.
Temperature limit tripped.
Thermostat needs to be adjusted colder.
Empty water bottle.
Mineral deposits clogging tanks.
Possible air pocket.
Possible ice build-up due to thermostat set too high.
Bottle is making a gurgling noise as it fills the tank.
Water dispenser is uneven.
Suggested Solution
Ensure seal is secure in drain plug and tighten
cap.
Replace with full bottle and wait 60 minutes for
water to cool.
Plug into the outlet.
Reset the breaker or replace the fuse.
Allow the temperature of the hot water tank to
cool for approximately 15-30 minutes. The tem-
perature limit thermostat will reset automatically
once sufficiently cooled and the cooling system
will reactivate automatically.
Adjust thermostat between high (cool) and low
(colder) levels to achieve desired temperature.
Replace with full bottle.
See Cleaning the Reservoirs.
Push down on the dispenser buttons to prime
the unit.
Inspect water line for kinks.
Unplug overnight, then reset. Adjust thermostat
to high, slowly increasing based on desired use
and need for cold water.
This is normal.
Make sure the dispenser is on an even surface
that can support its weight.
Page 11