Configuring Programmable Parameters; Programmable Parameter Reference - SEREN R301 Operator's Manual

R301 RF POWER SUPPLY OPERATOR'S MANUAL

Configuring Programmable Parameters

Navigating the Programming Menu
TO ENTER the programming mode, press the "PGM" button (Program/Run button – item 1)
on the front panel. The legend above the button will change from "PGM" to "RUN".
TO EXIT the programming mode, press the "RUN" button (Program/Run button – item 1) on
the front panel. The legend above the button will change from "RUN" to "PGM".
Pressing the "DOWN" button (item 2) moves down the programming menu levels.
Pressing the "UP" button (item 3) moves up the programming menu levels.
Pressing either the "UP" or "DOWN" buttons saves the programmable parameter. Pressing the
"ENT" button (item 4) also saves the programmable parameter.
parameters are saved in the R301 RF Power Supply's memory and are recalled upon power-on
PROGRAMABLE PARAMAETER REFERENCE CHART:
Programmable parameters intended for use by equipment operators are listed below.
Asterisk (*) indicates factory default setting.
LEVEL
1 Control Source
Note: Setting the control source
to Serial Control allows scrolling
and setting of serial parameters
(Levels 1a through 1B)
1a Serial Interface Protocol
1b Serial Baud Rate
2 Pulse Mode
Note: Setting Pulse Mode to
enabled allows scrolling/setting
of pulse parameters (Levels 2a
through 2b)
2a Pulse Frequency
2b Pulse Duty Cycle
3 Leveling Source Select
4 Analog Voltage Range Select
5 Power Leveling Select
Seren IPS Inc.
6100130000 Rev. 0.05
PARAMETER DISPLAY LINE 3
PANEL CONTROL
ANALOG CONTROL
SERIAL CONTROL
RS232
XXXXX BAUD
PULSE MODE ENABLED
PULSE MODE DISABLED
FREQUENCY XXXX Hz
DUTY CYCLE XXX %
POWER CONTROL
VOLTAGE CONTROL
RANGE 5V F.S.
RANGE 10V F.S.
FWD POWER LEVELING
LOAD POWER LEVELING
Page 27
The programmable
OPTION
PANEL*
ANALOG
SERIAL
RS232
19200*
9600
ENABLED
DISABLED*
0 Hz to 20,000 Hz
0% to 100%
Internal Power Sensor*,
External Feedback Voltage
5VDC*
10VDC
Forward Power*
Load (Net) Power