1. Introduction This User Guide is intended to provide application support for the ADV7604 evaluation kit. It also provides details on the set up and manual configuration of the evaluation board. Software drivers are available for this evaluation board - a separate user guide is available for these software drivers.
ATV motherboard and the video output module. To assemble the evaluation platform, plug the ADV7604 evaluation board into the Female AV Input connector of the motherboard and plug the video output module into the Male AV Output connector of the motherboard.
Figure 2 – ATV Benchtop Control Select ADV Register Control from the ATV Benchtop control panel. Select a script targeting the device on your evaluation platform (ADV7604 in this case) from the ADV Register Program Configuration window as per Figure 3.
4. Using the Evaluation Platform 4.1 ADV7604 Evaluation Board Hardware The following features of the ADV7604 evaluation board Figure 5) should be noted Input Video Connectors 4 x HDMI inputs 1 x Component input 1 x Graphic input ...
4.1.2 EDID Configuration There are two EDID options available to user on the ADV7604 board an external PROM on port D to which an EDID can be programmed or an internal EDID PROM within the ADV7604.
FPGA_RESET resets the FPGA and reloads the firmware S2 S7 are not used S9 resets the ADV7604 evaluation board with no handshaking to the application. If this button is pressed, hot plug must be reasserted. Serial interface ...
Analog Devices Inc. reserves the right to update any script or default as and when is required. Should this be the case, please use the following procedure to update either a script or a default.
Need help?
Do you have a question about the ADV7604 and is the answer not in the manual?
Questions and answers