How To Operate Zone B - McIntosh MHT200 Owner's Manual

How to Operate Zone B

The MHT200 includes the capability of being able to oper-
ate and control two audio/video zones, independently of
each other. Zone A is the Primary (Home Theater Listening
Area) with Surround Sound. Zone B is configured for a
Secondary Remote Location providing two channel audio
and video programs.
The MHT200 Front Panel Alphanumeric Display indi-
cates the Zone A Program Source Selected on the left side
and the Zone A Volume Setting on the right side. Refer to
figure 71.
The Front Panel Alphanumeric Display indicates Zone
B Program Source Selected on the right side and the Zone
B Volume Setting on the left side. Refer to figure 72.
Operating Zone B from the MHT200 Front Panel
To activate Zone B Control from the MHT200 Front Panel,
perform the following steps. Refer to figure 73.
1. Press the Front Panel STANDBY/ON Push-button, if
Zone A is not active.
2. Press the ZONE B Push-button and immediately press
the STANDBY/ON Push-button. Refer to figure 74.
54
Figure 71
Figure 72
Note: During the time the LED Indicator above the ZONE
B Push-button is illuminated (approximately three
seconds), the Zone B Input Source and Volume Levels
may be changed using the Front Panel INPUT and
VOLUME Controls. The Zone B Power may also be
switched Off by pressing the Front Panel STANDBY/ON
Push-button within the three second time period. If
Front Panel Control reverts back to Zone A (the LED
Indicator above the ZONE B Push-button is not
illuminated), press the ZONE B Push-button again to
activate control of Zone B.
3. Rotate the INPUT Selector Switch to select the desired
source.
4. Rotate the VOLUME Control to the desired volume
level for Zone B.
Operating Zone B from a Keypad or Sensor
To activate Zone B Control from the Keypad or Sensor per-
form the following steps. Refer to figures 75 and/or 76.
1. Press the POWER Push-button on the Keypad or using
a Remote Control aimed at a Sensor located in Zone B.
Note: When Zone B is switched On the MHT200 Front
Panel Alphanumeric Display will indicate ZONE B
ON, if Zone A is not active.
2. Select the desired Zone B Source and adjust the Vol-
ume to the desired listening level by pressing the ap-
propriate push-buttons on the Keypad or Remote Con-
trol. Refer to figure 75.
Figure 73
Figure 74