Table of Contents
Advertisement
Interpreting error codes
Code numbers
030 through 031
421 through 425
441, 442,
444 through 483 and
531 through 567
501 through 506,
508 through 516 and
571 through 582
591, 594 and 595
592, 593
507
68
When errors occur while you are sending or receiving faxes, an error message is
included on the Last Transaction and Last 32 Transaction reports. The RESULT
column of the report contains the word ERROR and an error code is printed to
the right of the message. These codes report the following error conditions. If
you resend a fax that reported an error, watch the front panel display for
messages. For help on messages, see "Understanding display messages".
Condition
Document misfeed
Sending error while dialing.
Sending error.
Receiving error.
Stop button was pressed while
receiving a fax.
Stop button was pressed while
sending a fax.
Reception memory full, reception
stopped.
Remedy
The document did not feed correctly. Try
resending.
Check for a dial tone, then try resending.
This may be the result of a bad connec`
tion. Try resending.
This may be the result of a bad connec`
tion. If you received this fax, be sure to
check it for completeness. You may want
to ask the sender to resend the fax.
Ask the sender to resend the fax.
You may want to resend the fax.
A fax exceeded the memory or cannot
print. If you received this fax, be sure to
check it for completeness. You may want
to ask the sender to resend the fax.
Advertisement
Table of Contents
