Error Codes - Canon EOS 30D Instruction Manual
Hewlett-packard digital camera instruction manual
Hide thumbs
Also See for EOS 30D:
- Instruction manual (307 pages) ,
- White paper (30 pages) ,
- Owner's manual (15 pages)
Table of Contents
Advertisement
Error Codes
Error code
Probable cause and solution
To exit the error screen, set the <4> switch <2> and <1> or
remove and reinstall the battery.
Error Code
Communications between the camera and lens is
Err 01
faulty.
Clean the lens contacts. (p.11)
There is a problem with the CF card.
Try any of the following:
Err 02
• Replace the CF card.
• Remove and reinsert the CF card.
• Format the CF card.
The CF card is full and cannot record further.
Err 04
Erase unnecessary images in the card or replace the
CF card.
The auto pop-up of the built-in flash has been
Err 05
obstructed.
An error other than the above has occurred.
Err 99
This error may occur if you use a non-Canon lens and
the camera or lens does not operate properly.
If an error code appears right after shooting, the picture might not have been
captured. When the camera is ready to shoot again, press the <x> button
and check if the picture was captured.
If an error occurs, the camera's LCD
monitor will display the error screen, and
the LCD panel will display an error code
like "Err xx." To resolve the error, follow
the instructions on the LCD monitor.
If an error keeps occurring, there may be
a problem. Write down the error code and
consult your nearest Canon Service
Center.
Countermeasures
183
- Quick Links:
- Basic Operation
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the EOS 30D and is the answer not in the manual?
Questions and answers
monitor on laptop
To connect a Canon EOS 30D to a laptop for monitoring, follow these steps:
1. Use the interface cable that came with the camera.
2. Connect one end of the cable to the camera’s
terminal, ensuring the icon on the plug is facing the front of the camera..
3. Connect the other end of the cable to the laptop’s USB port.
4. Turn the camera’s <4> switch to <1> or
5. On the laptop, when the dialog box appears, select [EOS Utility] and click [OK].
6. When the camera model selection screen appears, select [EOS 30D] and click [OK].
7. The [EOS Utility] screen will appear on the laptop, and the direct image transfer screen will appear on the camera’s LCD monitor.
Before disconnecting, turn off the camera first and unplug the cable by holding the plug, not the cord.
This answer is automatically generated