Cub Cadet Z-Force S Operator's Manual page 10

2. Remove the two shoulder bolts and lock nuts in the seat
pan as shown in Fig. 3-3.
3. Rotate the seat into position and secure the seat into place
with the previously removed shoulder bolts and lock nuts.
Be careful not to crimp or damage the wire harness while
installing the seat. See Fig. 3-4.
10 S 2— A
ection SSembly
Figure 3-3
Figure 3-4
& S -U
et p
Adjusting the Seat
To adjust the position of the seat, push the seat adjustment lever
to the left. Slide the seat forward or rearward to the desired
position; then release the adjustment lever. Make sure seat is
locked into position before operating the tractor. See Fig. 3-5.
Figure 3-5
Install the Rear Hitch Bracket
1. Remove the hex flange screws and flange lock nuts that
secure the hitch bracket and muffler mount bracket to the
bumper bracket. See Fig. 3-6.
Hitch
Hex Flange
Bracket
Screws
Figure 3-6
Flange
Lock
Nuts
Muffler Mount
Bracket