Camera Control Cable; Ground Wire; Power Module; Power "On" Indicator Test - JVC DV-180 Operation Manual

Dv-180 controller
Table of Contents

Advertisement

3.3

CAMERA CONTROL CABLE

If the Computer based Camera Control option is used with the DV-180, a cable is required on the 15-pin
connector located on the rear panel of the controller. To install the cable, connect the 15-pin plug (male) end
of cable (ACA203006600) to the rear panel of controller and connect the 9-pin end of the cable to the 9-pin
serial data connector on the computer.
3.4

GROUND WIRE

The DV-180 Controller is equipped with the provision for attaching a chassis ground to the metal controller
console. This ground helps eliminate static electricity problems and provides a hard earth ground if required.
A single 4-40 stainless steel screw is located adjacent to the power switch on the rear panel of the console
chassis. Fabricating the ground wire is the responsibility of the installer and is not provided with the
controller.
3.5

POWER MODULE

The power for the DV-180 Controller is supplied by a single wall mount power module. The unit requires a
12 VDC @ 500 ma version power module. To install the power module simply plug the unit into the AC
wall outlet and plug the DC plug into the jack on the rear panel of the DV-180 Controller labeled "POWER
+12 VDC". Caution: in the event the power is supplied by the user the center pin of the plug is ground DO
NOT reverse the polarity.
3.6

POWER "ON" INDICATOR TEST

When the system is powered on, the green "PWR" indicator will be illuminated and the function LED's
will sequence from all extinguished to all illuminated. This indicates the system is operating normally. The
power on test is complete when all indicators are extinguished with the exception of the green power
"ON" LED, and the camera 1 LED, which defaults to illuminated at the completion of the test.
3.7

ANALOG CONTROL CALIBRATION

Do not activate any analog controls (pan, tilt, zoom or focus) while the system is executing the power-up
sequence test. These analog pan, tilt, zoom, and focus controls are automatically calibrated during power-
on test.
JVC DV-180 PAN/TILT Operations Manual
7
Doc #: D0154-A

Advertisement

Table of Contents
loading

Table of Contents