Table of Contents
Advertisement
3.
INSTALLATION
Installation of the DV-180 Controller console version consists of merely attaching interface cables and
power module. The mounting hardware is the responsibility of the installer and is not provided with the
controller. The interface cables consist of up to four RS-422 cables to the DV-115 pan & tilt heads and one
RS-232 cable to the user's computer.
3.1
TOOLS AND EQUIPMENT REQUIRED:
There are only two tools required to install the controller, they are: 1/8 inch flat blade screwdriver for the 15
pin remote (LDCC) "D" connector on the rear panel of the unit. This connector is only attached in the event
the computer based CCU option is included, and a #1 Phillips screwdriver for attaching the ground wire to
metal chassis in the event it is required.
3.2
RS-422 CABLE INSTALLATION
This interface is the normal connection between DV-180 controllers and the DV-115 pan and tilt heads. The
figure below illustrates a typical RS-422 interface cable. These cables are terminated with conventional
telephone type modular six position four contact connectors. Each camera station in the system must be
connected to the controller via a RS-422 cable. Connect one end of RS-422 to the connector on the rear of
the controller. Connect the other end of the cable to the connector on the pan and tilt head labeled "RS422".
Note: pins 1 and 6 are not used.
1
2
3
4
5
6
Figure 3-1: Typical RS-422 Cable
JVC DV-180 PAN/TILT Operations Manual
960379-100
P/T Out -
P/T Out +
P/T In -
P/T In +
6
Black
Red
Green
Yellow
1
2
3
4
5
6
Doc #: D0154-A
Advertisement
Table of Contents
