Miele KDN 37132 iD Operating And Installation Instructions page 63

For additional stability of the appliance
in the unit, push the rods supplied in
underneath the appliance between it
and the floor of the housing unit.
^ Then secure handle q to one of the
rods r.
^ Use the handle to push the rod into
the guide as far as it will go.
Remove the handle and fit it to the
other rod and push this into its guide
as far as it will go.
Important. Keep the handle
somewhere safe in case you ever
need to fit the appliance into a new
housing unit.
^ Close the appliance doors.
Building in the appliance
^ If necessary, align the cover strip by
pushing it parallel to the top of the
unit - it should be set slightly back
and must not protrude.
^ Snap off any protuding end s on the
top fixing bracket c. It is no longer
required.
^ Refit cover b.
^ Refit cover e.
^ Push the plastic tab into the left-hand
aperture in cover t, and then fit the
cover in position.
63