Advertisement
3. Inserting batteries -
and install 3D batteries, matching the polarity markings.
Replace the battery compartment, make sure
it snaps back into place.
4. Replace battery compartment -
spotlight compartment. Screw on till the arrows match.
Mounting the LED Spotlight:
Determine which mounting method you need
1. Permanent mounting - Large screw mounting
a. Remove base by removing screw in the side
of the base. (see photo)
b. Pull fixture from base by pulling out the neck
of the base.
c. Position the base in the chosen location and drive
the 44 mm screw through the top of the base
(see photo)
d. Replace the light fixture by pressing the neck back
in to the base and replace the screw snuggly in to
the side of the base.
NOTE: Only tighten finger tight to keep from cracking or breaking
the base. DO NOT OVER TIGHTEN. Replace neck and light and
tighten screw on front of base.
Open the battery compartment
put back in the
Advertisement
