Front View; Type Drive Enclosure; Figure 2.26 Front View Of 2.5" Type Drive Enclosure (With Flange Cover) - Fujitsu Eternus DX60 User Manual

Disk storage system
Hide thumbs Also See for Eternus DX60:
Table of Contents

Advertisement

Chapter 2 Components
>

2.4 2.5" Type Drive Enclosure

IMPORTANT
2.4
2.5" Type Drive Enclosure
2.5" type drive enclosures contain 2.5" disks installed in the front, and expanders and power
supply units (with fans) in the rear.
2.4.1

Front View

With flange cover
Flange cover

Figure 2.26 Front view of 2.5" type drive enclosure (with flange cover)

P3AM-3042-06ENZ0
ETERNUS DX60/DX80/DX90 Disk storage system User Guide
Each enclosure has two power supply units (PSU#0 and PSU#1). The
power cords must be connected to the inlets of both power supply units.
When connecting the power cord right after it is disconnected, wait for
the STATUS LED of the power supply unit is turned off completely (about
10 seconds) before connecting it again.
DISK READY LED
Glows (
) or blinks green (
are operating normally.
DISK FAULT LED
Glows orange (
) when a disk has failed.
Blinks orange (
) according to the VDS (Microsoft Virtual Disk Service) commands.
Disk
Up to 24 can be installed in the ETERNUS DX60/DX80/DX90.
POWER LED
Glows green
(
)
when the power is
turned on.
READY LED
Glows green
(
)
when device is available
for use.
FAULT LED
Glows orange
(
)
when an internal device part
abnormality has been detected. Blinks orange
(
)
when a predictive error has been
detected.
IDENTIFY LED
Blinks blue (
) or turns off (
) as ordered via
GUI to identify the enclosure installation
locations.
67
) when disks
Copyright 2010 FUJITSU LIMITED
DE_No. label
Indicates the drive
enclosure No.

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Eternus dx80Eternus dx90

Table of Contents