Safety And Maintenance Guidelines; Important Safety Information; Safety Precautions - Lenovo LT1423pwC User Manual

Safety and Maintenance Guidelines

Important Safety Information

The power cord is designed for use with your monitor. To use a different cord, use only a power source and
connection compatible with this monitor.
WARNING:
Always connect your monitor, the computer, and other equipment to a grounded (earthed) power
outlet. To reduce the risk of electric shock or damage to your equipment, do not diable the power cord grounding
feature. The grounding plug is an important safety feature.
WARNING:
For your safety, be sure that the grounded power outlet you plug the power cord into is easily
accessible to the operator and located as close to the equipment as possible. To disconnect power from the
equipment, unplug the power cord from the power outlet by grasping the plug firmly. Never pull on the cord.
CAUTION:
To protect your monitor, as well as your computer, connect all power cords for your computer and its
peripheral devices (such as a monitor, printer, or scanner) to a surge protection device such as a power strip with
surge protection or uninterruptible power supply (UPS).
Not all power strips provide surge protection; the power strips must be specifically labeled as having this ability. Use
a power strip whose manufacturer offers a damage replacement policy, so you can replace your equipment if surge
protection fails.
CAUTION:
A certified power supply cord has to be used with this equipment. The relevant national
installation and/or equipment regulations shall be considered. A certified power supply cord not lighter
than ordinary polyvinyl chloride flexible cord according to IEC 60227 (designation H05VV-F 3G 0.75mm²
or H05VVH2-F2 3G 0.75mm²) shall be used. Alternative a flexible cord be of synthetic rubber.
CAUTION: To prevent the monitor sliding out of the cover always carry as shown below

Safety Precautions

Use only a power source and connection compatible with this monitor, as indicated on the label/back plate of
■
the monitor.
Be sure the total ampere rating of the products connected to the outlet dose not exceed the current rating of the
■
electrical outlet, and the total ampere rating of the products connected to the power cord does not exceed the
rating of the power cord. Look on the power label to determine the ampere rating (Amps or A) for each device.
Install your monitor near a power outlet that you can easily reach. Disconnect the monitor by grasping the plug
■
firmly and pulling it from the outlet. Never disconnect the monitor by pulling the cord.
Do not allow anything to rest on the power cord. Do not walk on the cord.
■
While using VESA mount application, the AC Inlet must face to down side. Do not face any other position.
■
iv