Connecting Wires To Terminals - Kenwood DDx155 Instrucion Manual

Connecting Wires to Terminals

Change the FUSE location to switch
ACC and B+ pin location on the ISO
connector.
FUSE ( 15A )
Accessory 1
(DDX1035/DDX1035M only)
Accessory 2
(DDX1035/DDX1035M only)
Blue/White (Power control/
Antenna control wire)
P.CONT.
ANT.CONT.
Red (Ignition wire)
Yellow (Battery wire)
Black (Ground wire) · (To car chassis)
White ª / White/black · : To front speaker (left)
Gray ª / Gray/black · : To front speaker (right)
Green ª / Green/black · : To rear speaker (left)
Purple ª / Purple/black · : To rear speaker (right)
36
English
To the power control terminal when using the optional power amplifier,
or to the antenna control terminal in the vehicle. (Max. 350mA, 12V)
If no connections are made, do not remove the cap.
ACC
B+
Audio Video input 1 (AV IN1)
• Video input (Yellow)
• Audio left input (White)
• Audio right input (Red)
Rear Preout
• Audio left output (White)
• Audio right output (Red)
Front Preout
• Audio left output (White)
• Audio right output (Red)
Purple/White (Reverse
sensor wire)
Light Green (Parking
sensor wire)
Extension cable (Accessory 3)
For best safety, be sure to
connect the parking sensor.
Connect to the vehicle's parking
⁄
brake detection switch harness.
FM/AM antenna input
Antenna Cord
Subwoofer Preout (monaural)
Rear View Camera Input (Yellow)
Ignition key switch
Car fuse box
(Main fuse)
Battery
Video Output
Connect to vehicle's reverse
lamp harness when using the
optional rear view camera.