Table of Contents
Advertisement
Accessories/Installation Procedure
Accessories
1
*
1
..........1
2
*
1
..........1
3
..........1
(2m)
4
..........1
5
*
2
..........2
Installation Procedure
1 To prevent a short circuit, remove the key
from the ignition and disconnect the ·
battery.
2 Make the proper input and output wire
connections for each unit.
3 Connect the speaker wires of the wiring
harness. (Accessory 2 )
4 Connect the wiring harness wires in the
following order: ground, battery, ignition.
(Accessory 1 )
5 Connect the wiring harness connector to
the unit.
6 Install the unit in your car.
34
English
6
*
1
..........6
(M5x6mm)
7
*
1
..........6
(M5x7mm)
*
DDX1035/DDX1035M
1
only.
*
2
DDX155 only.
7 Reconnect the · battery.
8 Press the reset button.
9 Perform the Initial Setup.
WARNING
• If you connect the ignition wire (red) and
the battery wire (yellow) to the car chassis
(ground), you may cause a short circuit,
that in turn may start a fire. Always connect
those wires to the power source running
through the fuse box.
• Do not cut out the fuse from the ignition
wire (red) and the battery wire (yellow). The
power supply must be connected to the
wires via the fuse.
¤
• Mounting and wiring this product requires
skills and experience. For best safety,
leave the mounting and wiring work to
professionals.
• Make sure to ground the unit to a negative
12V DC power supply.
• Do not install the unit in a spot exposed
to direct sunlight or excessive heat or
humidity. Also avoid places with too much
dust or the possibility of water splashing.
• Do not use your own screws. Use only
the screws provided. If you use the wrong
screws, you could damage the unit.
• If your car's ignition does not have an ACC
position, connect the ignition wires to a
power source that can be turned on and
off with the ignition key. If you connect
the ignition wire to a power source with
a constant voltage supply, such as with
battery wires, the battery may be drained.
• If the fuse blows, first make sure the wires
are not touching to cause a short circuit,
then replace the old fuse with one with the
same rating.
• Insulate unconnected wires with vinyl tape
or other similar material. To prevent a short
circuit, do not remove the caps on the ends
of the unconnected wires or the terminals.
Advertisement
Table of Contents
