Lubrication; Articulation Adjustment - Shoprider Scooter Owner's Manual

If The Scooter Does Not Run:
a) Check circuit breaker
b) Check all connectors
c) Check to make sure that the
battery adaptor is disconnected from
the charger plug.
d) Check to make sure that the
freewheeling device is in the run posi-
tion.
If your SHOPRIDER™ is still not run-
ning, contact your nearest authorised
SHOPRIDER™ dealer.

LUBRICATION:

Approximately every six months you
should lubricate the following parts on
your scooter.
The lubrication points are as follows:
• Seat Lever
• Under Seat
• Wheel Bearings
• Axle of Scooter
All lubricates should be done with
WD40 or similar lubricant.
Note:
The breather hole on the top of the
transaxle is NOT a grease nipple.
Please DO NOT put any lubricant
in the transaxle or you will void
your warranty.
ANY OTHER LUBRICATION OF THE
SHOPRIDER™ MUST BE DONE BY AN
AUTHORISED SHOPRIDER™ DEALER.

ARTICULATION ADJUSTMENT

This adjustment is located on the seat
post approximately half way down.
There is a bolt on either side that can be
adjusted. By loosening these bolts you
can allow more side to side action on
the scooter.
This adjustment is done at the factory
and should not be adjusted unless the
terrain is extremely uneven.
If any other situation or questions arise
about your scooter, do not hesitate to
call your dealer.
page 16