Resetting The Access Point To Factory Default Settings - Ruckus Wireless ZoneFlex 7762 Getting Started Manual

Resetting the Access Point to Factory Default Settings

Step 2: Attach the Dynamic Bracket to the Access Point
If you are not connecting 5GHz external antennas to the standard N-type
CAUTION:
antenna interfaces on the Access Point, make sure that the metal caps remain installed
and securely fastened to protect the interface from elements, such as water and dirt.
You have completed connecting external antennas to the Access Point.
10
Resetting the Access Point to Factory
Default Settings
You can reset the Access Point to its factory default settings by shorting pins 3 and 4 on
the DC connector. Use the electrical shunt that is provided with the Access Point package
to perform this procedure.
NOTE: The Access Point can only be reset to factory default if it is using PoE.
1. Verify that the Access Point is using PoE as its power source.
2. Take out the electrical shunt that is supplied with the Access Point.
3. If the DC connector on the Access Point is protected by its cap, remove the cap. Take
note of the location of pins 3 and 4 (see
52
Figure 41).