Troubleshooting - Bissell Proheat Premier User Manual

Troubleshooting

problem
Reduced
spray or
no spray
Dirtlifter®
powerbrush
does not turn
cleaner
not picking
up solution
please do
not return
this product
to the store.
www.bissell.com
16
possible causes
Water tank may be empty
Tank may not be seated
completely
Pump may have lost prime.
The belt is off or broken
Circuit breaker on machine may
have tripped
Tank may not be seated properly
Tank may not be assembled
properly
2-in-1 water tank is empty
2-in-1 water tank has picked up
maximum dirty water and red
float door has closed.
Red float "door" in the tank may
have closed as a result of bumping
object or moving machine back
and forth too quickly
Red lint screen near air duct
is dirty
Other maintenance or service not included in the manual should
be performed by an authorized service representative.
Thank you for selecting a bissell product.
for any questions or concerns, bISSEll is happy to
be of service. contact us directly at 1-800-237-7691.
800.237.7691
WaRnInG
To reduce the risk of electric shock, turn power switch
off and disconnect plug from electrical outlet before
performing maintenance or troubleshooting checks.
Remedies
Turn power off. Fill heavy duty
bladder with hot tap water. Do
not boil or microwave water.
Turn power OFF. Remove and
reseat tank
Turn power OFF and then back ON.
Wait one minute, then depress trigger
Turn power OFF and unplug unit
from outlet. Follow instructions on
page 14
Turn the machine OFF and unplug
from outlet. Check to see if foreign
object is caught in brush roll.
Remove object. Plug machine in to
reset circuit breaker
Turn machine off. Pick up the 2-in-1
water tank and re-seat it so it sits
snugly on the unit.
Turn machine off. Make sure the tank
latches on both sides of the tank are
latched properly. To make sure they
are both latched properly, pick the tank
up by its handle.
Turn machine off. Check fluid levels in
heavy-duty bladder.
Turn machine off. empty 2-in-1 water
tank. Refill heavy duty bladder with
clean hot tap water and replace.
Turn the machine OFF , allowing red
float door to release into the open
position. Turn unit back ON to
continue cleaning. be sure your
forward and backward strokes are
done at a slower pace.
Turn machine off. Follow cleaning
instructions in step 4 on Page 13.